I have a 1993 VXR 1fzf (carburetor) 80 series, (factory locked, barn doors, factory snorkel, rear steps, 5-speed manual tranny, rear AC, and ice box), anyone have any experience with importing to california(LA), or do i need to install a catalytic convertor and it should pass california smog...
I searched for a longer brake line OEM part #’s but I couldn’t find anything on Mud, the closest was NAPA #’s which we don’t have here and I prefer Toy, the one I got was a T100 part# 96940-34606 searched for this part and it was superseded by this Part # 96940-34605 (is this longer than our...
My temperature gauge doesn’t rise above this mark but takes a few minutes to reach it when cold, and the oil pressure almost goes up to just before the high limit, is it normal?
It’s a Gulf spec cruiser if it makes any difference (middle east), did they have different sized radiators, if...
I have 1992 fzj80 with 1fz-f engine (carb), i am wondering if anyone has a High Altitude Compensator on it, where do the hoses connect to the carburetor?
When a part is back ordered from a Toyota OEM parts supplier, how long does it (usually) take for the order to fulfill, i.e. Locker ECU, and harnesses for locker.
(note to self, one more reason to deal with Cruiserdan, and not venture to other OEM suppliers.:bang:)
Anyone have the part number for the floor wire number 3 harness to plug with rear diff-lock actuator.
i am trying to order bunch of stuff to retrofit diff-lockers from CruiserDan, including the floor wire number 3 harness, but i can't seem to get a part number on it. Anyone who has the part...
I need to know where does the plug and sensor from the front locker connect to, as I can’t find a harness to connect it to? Please anyone with an axle swap experience from non locker to locker axles chirp in.
The back I figured it out (I think) from other threads, as it connects to the harness...
i Pm'd this post to Cruiserdan, but i think his box is full,s i will try the forum instead. sorry if i broke any forum rules.
Dan,
I bought 2 locked axles for my 1fz-f (not EFI) 1992 cruiser (foreign car Middle East spec), so lockers were an option on it(but not on mine), my truck is a...
Any idea How it can be modified to an 80 series rear. The main problem if I fit it as it is, will be it will hang a good 3 inches down from the bumper. It is made of a mix of cast iron and normal thick wall steel, weighs at least 200 Lbs.
I am a Newbie (bear with me please) I have been lurking around here for a few months, I looked over the FAQ and searched mud, yet haven’t found a specific answer to this issue otherwise I gained a lot of knowledge for other stuff.
My question is can I do a full axle swap front and rear to have...