So does the metal socket just pull up out of the plastic housing it is in? I have the same symptoms. I pulled on the socket with a pair of needle nose pliers, but it doesn’t come out.
also wondering do both tail lights use the same ground point? Since the problem is on only one side, it seems...
Wow! I have owned my LX for over 10 years and spent a lot of time on this forum. But I just found this thread yesterday. Took me about 20 minutes (half of which was locating tools and wire). I didn't even remove the seat. Just moved in forward as far as it would go, and then reached in over...
I should mention that all the linkage rods appear to be connected properly and none of the retainers for those is broken. When I try to manually lock using the lock pin, it still does not lock.
I was having a problem where my rear hatch would not lock (always unlocked). I assumed it was the actuator, so I replaced the actuator and the problem was not fixed. It still does not lock. When I try to lock using the fob, the lock pin (which you would raise or lower to manually lock/unlock)...
Thanks very much for the detailed suggestions. I ordered birfs from justdifferentials.com. These are Nitros, but they are the OEM replacements, not the Chromoly birfs. I explicitly indicated to their rep that this is a highway vehicle. Also, got the knuckle replacement kit from them with the...
So, would my t-case in my LX normally be locked. As I mentioned, I have never paid any attention to the issue of the lockers, so I don't know what my situation would be. I have noticed that people have mentioned a switch or a light on the dash related to this and I don't think I've ever...
'97 LX450 228K
So, recently my DS birfield started clicking. I started reading up on doing the service thinking I had a while to get that done. However, yesterday the click turned into more of a clunk and I could feel it in the steering wheel. I stopped the car, called a tow truck and had it...
So my situation looks sort of like Cass007's.
I can put up with going through 1 Qt. of oil every 1000 miles or so, but my exhaust smells awful -- and not just at start up. Does this make it seem more likely that I have ring issues as well? Or could this be the catalytic converter not doing...
Just finished a third repair on mine. First 2 I used Locktite Plastic glue. I just glued the edges, so I don't think it had any surface area to hold. Looked around for info on best glue for polypropylene. One website tested several and recommended JB Weld PlasticWeld. I used that this time...
Trying to locate some points in the door lock wiring. The table in the section on the door locks refers to these pages, but I don't seem to have those in my e-copy of the EWD. Anybody have a copy?
thanks,
I've been trying to troubleshoot problems with my power door locks for a while. I've read the threads on the motors and the cracked arms in the actuators, but my problem currently seems to be affecting all the doors. Today I checked to see whether the locks behaved differently depending on...