For sale Powertrax rear locker for 68-98 Land Cruiser 9.5 inch semi floating axle.
Part number 9220883005.
This was installed in the rear of my FJ 60 for just a few months before I came across a set of thirds with lower gears and an ARB.
It is in like new condition with no rust or damage.
These...
Ok, laugh if you must, but two or three boat trailer rollers cut to desired length with a bandsaw will do the trick for about $30-$40. Just find them online and try to match up the hole size. These are usually rubber, but poly may be out there too. Just saying...
Ordering could be a bit easier. I found my way to the online parts store but struggled to find a way to enter the key code. Ended up using "Add a note to order" but I almost didn't see the text to open the dialog box. Might just by my monitor though. (or my eyes)
Maybe add a hyperlink...
I know this is an old thread but I was looking for more leg room in the 60 and was not finding any good solutions so I decided to see what I could do.
First I removed the drivers seat and flipped it upside down on a stack of buckets.
Then I cut some 1 inch steel flat stock to 14 3/8 inches.
I...
NV4500 (GM) 5 speed with 5.61 first gear ratio purchased new from Advance Adapters and has less than 50,000 miles on it. Includes the Chevy V8 bell housing, adapter for 19 spline FJ60 transfer case, clutch fork, slave cylinder bracket, and 4wd shifter pivot stud.
Transfer Case is from an FJ60...
They can be really picky about the exhaust too. Don't like to see any modification to the pipes before the cats or O2 sensors. Toyota frame can cause trouble here. Trying to squeeze it inside is tough. Keep us posted.
Might be best to discuss tank options with the referee. Maybe they would be OK with the Toyota tank as long as the vent lines were hooked up. Maybe the Toyota tank is too small for the EVAP to work properly. Most GM trucks have 20 to 35 gal tanks and the EVAP purge is calibrated for the tank...
If I recall, the problem with the tank was a baffle inside could become loose and bang around inside the tank. You may be able to hear it when you are low on gas. The baffle is designed to stop sloshing of the fuel and reduce fuel starvation when cornering. It's not much of a safety issue but...
I was out there Sunday to grab an AC hose. Too bad someone cut it when they removed the compressor.
This thing has 333000 on the clock and a bit of rust in all the usual places but I don't remember seeing any holes.
The radiator looked brand new. Seats and carpet were rough. Didn't see any big...