Updated Jul-1 to add a bunch of parts. All prices are +shipping. Located 22314 (VA).
Photos here.
Source: misc 70's FJ40
Weber Carb $150 working when pulled. Included are rebuild kit and manual choke conversion kit.
Trollhole carb $50; pulled working from 87 2F; rebuilt and very clean, but...
I have an DUI HEI distributor in my 40 with significant vertical shaft movement - something like 1/4 in.
Context: I had it at a shop last fall due to persistent electrical issues that kept causing it to burn out parts. They had the whole thing apart and I'm guessing didn't reassemble correctly...
I drained my transmission yesterday and found a metal chip in it. I popped the cover and the forward most gear has a chipped tooth. The lower gear that mates with it looks fine, as does all the other gears. It was running fine, and only came out as part of an engine swap.
Should I run it, fix...
Need a good running 2F in northern VA. Ideally something mid-1980's, but interested in anything in a known good condition. Intended for a '76 FJ40.
I can figure out pickup/shipping if needed.
Hi, I have a 1976 40 in Alexandria (Old Town area). The motor locked up last week and won't turn either way. It had dumped oil and I assume it's toast. I had put that last motor in from a donor truck 5 years ago ('78 2F block with a rebuilt '74 F.5 head). Unfortunately I no longer have a place...
in the middle of swapping an F.5 to a 2F. It has a 4spd trans, but surprise, surprise...a 1F flywheel and 3 fingered clutch. The clutch rebuild I've got is diaphragm, so I'm stuck until I can get a 2F flywheel.
I'm in west chicago (60189), and can drive a couple hrs if needed.
On a side note...
I've done a little research around the forum, and despite quite a few threads on this subject I would appreciate some validation before diving in...
Situation:
- I've got a 12/73 or 1/74 1F. It has a nicely rebuilt head, but a cracked block.
- The best replacement option I found is a long...
I've got a cracked block and am looking for a replacement. the head was recently rebuilt so I'm just looking for the block.
The manufacture date of the block that needs replacing is late '73 - early '74 (Specter Off-Road, Inc.-Landcruiser Parts & Accessories -Engine Serial Numbers), block #F...
I'm cutting out at 76 FJ40 tailgate blank and am looking for a tailgate and all hardware to replace it.
Preferred shipping to Chicago (60016); second option pickup near Chicago or CA bay area.
Top shock tower pin for a '76 FJ40
Part 25 in this diagram...SOR is out of stock.
Specter Off-Road-Land Cruiser Parts - Page 102-Suspension
Location: Chicago, IL (60016)
Thanks
I snapped the shock mount bolt off the back left u-bolt plate today on my 76 FJ40. My other one isn't great either, so if any one has a decent pair of rear u-bolt plates would be great. I'm hoping to have them in Chicago by next weekend. Thanks
I've been having some persistent electrical problems and could use some simple wiring validation. I have a new battery, starter, alternator, and voltage regulator. The new alternator has be bench tested and was putting out around 14.7 at peak. In the truck, I'm getting an even 12.3v which is...
I've been searching the forum and contacted a couple bolt sites with no luck. I need a head bolt for a '73 F engine, which is discontinued by Toyota. Bolt specs are:
Standard: JIS
Head: 19mm Hex washer
Bolt Diameter: 13mm
Thread Pitch: 1.75px
Thread Length: 30mm
Length: 145mm
Grade: 5?
Any...