Two front, two rear headrests. These will fit 70 or 80 series Land Cruisers.
10mm chrome posts
150mm post spacing
Please take note of the notches on the sides of the headrests posts. If they do not match, you can swap the receivers side to side..
Dark, navy blue from a Hilux Surf. The...
My 24V 4WD control switch (84724-60030) was starting to bother me in how ratty it looked:
Unfortunately, the 24V version is no longer made. BUT, the 12V is still made:
12V 4WD switch: 84724-60020
24V 4WD switch: 84724-60030
In doing research, I found that both switches use the same 12V...
Purging leftovers from the H55F manual transmission conversion.
Parts were sourced from around the world. Assumed that everything is fully-functional. Used parts are untested unless noted otherwise. New parts are unused and OEM.
Would love to sell everything at once, but that is...
The Japanese transfer case instruction decal is NLA. It sits on the glove box door and looks like this, but it's less blurry in real life.
If anyone has this decal, could you post a super clear photo of it? I am going to make some.
Thank you.
Trying to compile a list of ground points on the 1HZ 70 Series. So far I have:
ENGINE COMPARTMENT
Battery to frame (behind the front battery)
Battery to engine (near the p/s pump)
Transmission to frame (near the starter)
Engine to frame - ??? does this exist ???
Front right near air box -...
Really, really dumb question here: The parking brake bellcrank has a stop pad on it. Toyota has an adjustment spec for this stop pad.
What is the purpose of this stop pad, and why does the spec even matter?
(picture shows the extended position, not the adjustment position)
I just swapped out my KMH speedometer with this beautiful MPH speedometer. I was hoping it would fix my speedometer being off by 8mph. It didn't. It was still off by 8mph vs the GPS app.
I figured the cable might be rusted up and binding in the sleeve, so I replaced the speedometer cable...
My HZJ77 left me stranded a few months ago. The A440F automatic transmission blew up internally with zero line pressure.
I always felt that the automatic transmission robbed a lot of power. I mean, the thing is absolutely massive:
Instead of rebuilding the automatic unit, I decided to...
Just got a new-to-me clutch pedal box out of a 2004 HDJ79. It's got a weird spring system on the side of it.
Anyone seen this before? I'm trying to figure out the purpose of it.
I am in the middle of doing a manual conversion on my HZJ77. Looking for the ENTIRE hydraulic system (pedal, master, booster, accumulator, etc).
Happy to buy new or used.
Not sure that it matters, but 1HZ engine going to an H55F trans.
Located in Atlanta. Thank you.
Looking for a pair of clamps from a 70 series middle seat. The clamp that holds the seat to the floor.
I am also happy to buy an ENTIRE trashed middle seat as well, so long as the clamps come with it.
Looking for this console with both shift boots. Depending on the condition, I will pay a LOT.
I believe it is manual transmission HZJ77 specific, but it may have been used in other ZX-trimmed models.
Apologies for the request, as I am fairly new to MUD. I use the classifieds often and love using them. With that said, the classifieds are difficult to navigate with all cruiser series in the same spot (with the exception of JDM, they have their own area). 40, 70, 80, 100, etc are all lumped...
If you installed aftermarket seats in your truck, you probably have what I need.
Looking for a pair of suspension seat RAIL SLIDERS (i.e. the middle bracket that attaches the actual seat to the suspension base). These typically get thrown away during a front seat upgrade.
I do not need the...
If you installed aftermarket seats in your truck, you probably have what I need.
Looking for a pair of suspension seat RAIL SLIDERS (i.e. the middle bracket that attaches the actual seat to the suspension base). These typically get thrown away during a front seat upgrade.
I do not need the...
Has anyone replaced their suspension seat crank handles? Part number 73080-90K00 totally discontinued for years.
I'm looking around for some similar window cranks that I can adapt. Hoping someone has crossed this bridge already.
Since I had my fuel tank out and drained, I decided to see how calibrated the fuel level sender was.
Full tank is 23.8 gallons per everywhere. I started at 8 gallons:
Essentially, I would say the fuel level gauge is properly calibrated at the top end with a spare "reserve tank" of...