Looking at trying to remove these. Will I run into any issues?
For the rear lowers I have the city racer replacements. Just not sure about the quarter window.
Good evening guys! I am so close to finishing my factory A/C install in my non AC 83 60. New hoses are being made as we speak!
I could use some help identifying the location of some wires.
There are two wire bundles that come out of the firewall next to the evaporator. One wire goes to the...
I just replaced my water pump and thermostat among other things. I fired it up today to find coolant was leaking out of the driver's side lower thermostat housing bolt. Is this a common occurrence? What would the fix be? I did apply a small amount of FIPG to the threads prior to install. I think...
I looked and haven’t seen this asked yet.
What vacuum lines are actually necessary post sniper install. There are a ton of Ts that lead to capped manifold ports etc.
I’ve seen sniper installs on SBCs where there are only a couple lines. Ie to the dizzy etc
I’d really like to eliminate as...
Pulled from 1983 FJ60. Worked great no noises. Thought it was leaking but ended up being the low pressure line. Pulled to swap to Saginaw. 190k miles unknown if original. Recommend rebuild prior to install since age unknown.
Make reasonable offer via text 6027699800
Jeff
Hey guys and gals,
My wife and I own a very small gun shop. We started out a couple years ago doing ecommerce and we are looking to open a storefront in Peoria, AZ. That being said we need to dramatically boost our sales over then next couple months to help off set the costs.
SOOOOOO.... for a...
I'm aiming to rebuild my case next spring. 83 FJ60. Currently have a 4spd/stock case/stock diffs rolling 33x10.50r15s.
I plan to keep the 2F/4spd until they blow. It runs great now and hopefully with some preventative maintiance we should be in the clear for a while. Future plans will be...
www.BlasterTactical.com
Doing a limited quantity run on these so PM me ASAP if you want in. I'm making these as a hobby and to recoop some of the initial buy in I incurred from buying all the wire and tools needed to complete my project. I hope to do batches of 5 or so at a time until my...
Hopefully someone can provide some insight!
1983 FJ60, 2F, 4 SPD.
Transmission shifts into all gears perfectly and pulls hard. Clutch is nice and firm.
Problem: or this may be normal. Haven’t owned a stick in a hot minute. When I release the clutch in neutral I get a swirling contact noise...
Both of my front fenders are complete trash. I was looking at getting a left and right from them on my way down the coast next month.
Any opinions on them or other recommendations? Also need a front valance, no headlight washers.
Jeff
Looking for a passenger door mirror for my 1983 FJ60. Glass needs to be intact, housing can be faded/rough but serviceable. Please send pictures and price.
Shipped to Peoria, AZ 85383
PM or Text 6027699800
Instagram build @rustyFJ60
www.BlasterTactical.com
Hello all!
Figured I would create a build thread for my 1983 FJ60. I found this rig days before deployment. The PO was very less than honest about the condition and a master of deceit. I did end up purchasing the rig even though there was a...