Search results for query: *

Forum search Google search

  1. F

    rim verse tire width

    is there a chart for this somewhere. the tire guy told me that i need a 10 inch wide rim to put 33x10.5 swamper radials on. i havent picked the rims up yet from another shop, but i was going to get 8 inch wide. i see folks putting huge tires on small rims, but whats really recommended
  2. F

    master or slave cylinder

    clutch pedal dropped to the floor, no leaks, and a full reservoir. how do i check to see which ones broke, or do i just replace both. there is more torque in that f motor than i would have thought, truck was going forward at about 3 miles an hour when i hit a wall and folded the stock front...
  3. F

    OME installation

    conflicting info when doing the search for correct install, just want to put it in right the first time. first pic shows the rear spring, (+) side is the short side and goes toward the center of vehicle, long side of shackle toward the spring as shown with extra bolt inbound second pic is front...
  4. F

    tires and rims

    did the searches and still confused, seems theres some info conflicting and its probably due to everyones different upgrade etc. will steel american racing rims with a 4 inch backspacing fit a 1971 with origional drum brakes all around. and will a 33 x 9 inch tire fit with origional suspension...
  5. F

    lift kits

    i see the 2 inch kits from sor at 869 for the set, are they made well, the ome i see priced at 1200 dollars for the set. is there that much difference between the 2. on road and off
  6. F

    insuring lifted vehicles

    any problems insuring modified lifted cruisers, my brother just put a heep on the road and that was the first question the insurance company asked. he is in nh, im down in mass
  7. F

    parts and service list ?

    ive only bought one part for my new 71 so far, it was a 50 dollar light switch, is there a list of sources for new and used parts and services. i dont see one anywhere and it would be helpful. isee the parts by google section, has anyone made up a good list, my one experience with sor seemed...
  8. F

    1971 ballast resistor

    truck is starting real hard then runs fine. starts fast if i jump the ballast and i dont see a ballast resistor in the ignition diagram. did this truck origionally have one or does it need it. will this burn up the points quicker without one. the truck is a 71 with origional f motor, no mods any...
  9. F

    new owner with some questions

    new to this forum styl as well, i see i posted this on someonelses question below, http://img.photobucket.com/albums/v2...n/100_1269.jpg this was a freeby with a blown motor, had it for a few years and just started to work on it, swapped out the motor with another f motor and its running good...
Back
Top Bottom