Search results for query: *

  • Users: fj40fax
  • Content: Threads
  • Order by date

Forum search Google search

  1. F

    Wanted  WTB 1FZ-FE

    I threw a rod through the block on my '95 FZJ80. Looking to buy a new engine. Hopefully close to Utah, but let me know what you have.
  2. F

    RTH Can someone measure a 4spd tcase sleeve?

    I need some real time help. The shop that is putting my tranny back in lost the sleeve that spaces out the rear yoke. The ID is easy enough, just has to fit over the shaft, but I could use OD and length measurements. They can make one easy enough on the lathe. Thanks, Fax
  3. F

    40 needs a ride/drive from Proffitt's to SLC this week

    My 40 is finished at Proffitt's and I need to get it back this week so I can take it to Scout Camp. It runs great and would be a good way to get from Delta to SLC (actually Pleasant Grove but we can get u where u need to go). Feel free to give me a call on my cell: 801 - three one eight - 3632...
  4. F

    Wanted  WTB '80 FJ40 Turn signal/High beam control assembly

    I'm looking for aturn signal/high beam control assembly for my 1980 FJ40. I am sure there are some out there that have done tilt columns that have one laying around. It is white and plastic for the most part with the wires coming out of the back and the lever out the side. I can email pics...
  5. F

    Anyone running a 350/700R4 in a '80 or later?

    Is anyone running this combination (SBC, 700R4) with a clutch fan in a 1980 or later FJ40? I am wondering if it clears the gas tank well, and also looking at options for a middle crossmember, as I am pretty sure this will be in the way. Thanks, Fax
  6. F

    Wanted  Pre '69 Brake master Cylinder

    Looking for a pre '69 fj40 brake master cylinder in working condition to use for a clutch master cylinder on my V8 conversion. PM me if you have one, or feel free to email me at fj40@dccrusr.com Thanks, Fax
  7. F

    Help, Poorly Running 80

    '95 FZJ80 all stock. I tried a search for this, but it is difficult to describe in a searchable fashion. The 80 has been running poorly for about a week. It would stumble only on initial acceleration, then catch and run just fine until coming to a stop again. Even under heavy...
  8. F

    Rancho RS60612 Add-a-Leafs

    I have 4 Add a leafs that are used to lift a stock 40 1.5-2". This is enough to clear 33's with no rubbing. Here is what Jeff Zepp said about them on the LCML: "Here's the deal: Rancho add-a-leafs P/N RS60612 contain two add-a-leaves, 3/8 center pins and 5/16 center pins, they are $60 each...
  9. F

    J Springs

    SOLD, Thanks Jeff! I have a set (4) J springs that I need to sell. They were only on the truck for about a year when they were replaced with 6" lift springs. I would like to get $200 plus actual shipping. They are in 2 12x12x24 boxes, but I have no idea what they weigh. Zip 84062. It is...
  10. F

    Old bikini top laying around?

    Does anyone have an old soft top or bikini top they are throwing away? I just put on a full cage, and my bikini top will not fit anymore. I have some trampoline material that I am going to make a new top out of, but I need the plastic piece that goes in the channel on top of the windshield. It...
  11. F

    Shocks for J springs

    Is anyone running a different shock than the OME L shocks on their 80 in combination with j springs? It seems the compressed length for the L shocks is too short (just from bump stop lowering recomendations). I don't know if there is one with similar valving to the OME but has different travel...
Back
Top Bottom