Any last minute tips before I pull the camshaft gear. Not sure how it happened but I tore the timing plate gasket and now have a bad oil leak.
Pic of the plan:
http://i249.photobucket.com/albums/gg216/bbalbano/ih8mud/Gear-1.jpg
Im pretty sure the plate will slide around the...
This carb came with a rebuilt motor that I just bought, it looks pretty new. When I had it back together I hooked up a fuel line and the float looked to be stuck. I opened the top and moved the float and spring inside. All gaskets appear to be solid and in good shape jets and needles look clean...
I have a new 4spd clutch that Id like to use with my 3spd. If I use the 4spd flywheel will the clutch be compatable with my 3spd. The input shafts are very close in length 1/10 of and inch difference,and the pressure plates are the same. I have the throwout bearing for the 4 spd as well and all...
40 parts:
4 spd tranny 16 spline output - $75 ran when pulled
Water pump used in mini truck p/s conversion - $20
2 groove water pump pulley(2) $20
Thermostat housing 71 F motorGood Shape - $20
Harmonic Balancer 2 groove - $30
Intake Manifold 71 F motor Good Shape - $25
Exhaust Manifold 71...
Ok, so after a spun bearing in my F motor I have been able to aquire a good running 3F motor from a fellow mudder. and I have help to complete the wiring for the computer etc. I have a few questions and Im sure there will be many more.
1) can I use my current clutch, will it bolt to the 3f...
Looking at a few motors and I need to figure out how to ship them. I would new a complete motor brought to FL from either of these locations.
Thanks
Brian
I blew a rod or something! It sounds like its in the lower end and it banging as load as can be. This sucks. What are my options?
Not going the 350 route. Debating putting in a 2f or reparing what I have if it can be fixed, the f motor I have has pretty low mileage it just sat for a while...
THIS THREAD IS POSTPONED UNTIL I FIX THE FJ40. I BLEW A ROD WHILE DOING 80 ON THE HIGHWAY YESTERDAY. BETTER NOW THAN AFTER A TRADE...
bbalbano/71FJ40 - Photobucket - Video and Image Hosting
My build thread is in my signature line.
There are a few loose ends that I...
4.99 at discount auto
http://i249.photobucket.com/albums/gg216/bbalbano/DSC02251.jpg
Put some electrical tape to protect from glue.
http://i249.photobucket.com/albums/gg216/bbalbano/DSC02253.jpg
Hot glue gun
http://i249.photobucket.com/albums/gg216/bbalbano/DSC02254-1.jpg...
Looks like something got fried in the upper left corner..
http://i249.photobucket.com/albums/gg216/bbalbano/DSC02203.jpg
If so anybody got one laying around??;)