Engine temperature gauge on original cluster goes to cold while the engine is on. All other gauges are working correctly, and power is hooked up according to the wiring diagram. Any suggestions?
Trying to find both LH and RH front bumper supports that are sandwiched between the bumper and gussets. See below. If I can’t source, does anyone know the measurements so I can have them built?
Trying to source an Oil Pump for a 1971 40 series. SOR has them, but was hoping to see if there was a source out there that didn’t want to charge a mortgage payment t.
I am still very new to working on cars, so Posing a question to the group… I have replaced the fuel pump, fuel line, gas tank and carburetor on my 71 40. Weber carb, OEM fuel pump and gas tank. Running all soft fuel lines current, it they are new. I can prime the carb and fuel pressure is...
Does anyone have pictures of installing the SOR jump seat bracket kit for early year FJ40 with a roll bar? I’m trying to do the install and they’re not much help at all.
Does anyone have AVM locking hubs on their rigs? I have a 71 40 that I just did a brake conversion on and the original Warns are shot. With a 6 spline axle, I’m finding limited options.
Saw the AVMs on Cool Crusiers and was wondering if anyone knows much about them.
Anyone know how to source just the cable portion of the FD for a 71. Picture is included. I removed it from the housing and wanted to know what people have done.
I am still learning the mechanical ropes here, so bare with me... I have a 1971 40. I replaced the carb with a new one, but am still having trouble getting the engine to stay running.
Steps I have taken so far:
1)New Battery
2) Replaced Carb with a new one(..
3) Replaced Ignitor Coil.
4) New...
So, I accidentally pulled the spindle cover off when removing the passenger side drum. It slid back on but the spindle won’t move. I’m going to have to rebuild the knuckle aren’t I?
Newby here...
I am in the midst of the disc conversion and am running into an issue with removing the hub housing. It looks like there is a C Clip retaining, but it isn't a C Clip(i've put a 90 degree pick behind it and it won't move).
I removed the small hex bolts also.
Any and all ideas...
I know this topic has been well discussed, so forgive me if I sound stupid.
Can you do a front disc conversion with riveted wheels? My understanding is the clearance from the calipers don’t work with rivets. Can you get the clearance needed by adding spacers?