71 FJ40 US specs. Correct sender for the year and engine(F). Bought from Crusier Corps, and confirmed correct part number. Getting power to the sender and resistance is changing. When I turn the engine off, the needle on gauge goes towards warm.
Engine temperature gauge on original cluster goes to cold while the engine is on. All other gauges are working correctly, and power is hooked up according to the wiring diagram. Any suggestions?
Trying to find both LH and RH front bumper supports that are sandwiched between the bumper and gussets. See below. If I can’t source, does anyone know the measurements so I can have them built?
Trying to source an Oil Pump for a 1971 40 series. SOR has them, but was hoping to see if there was a source out there that didn’t want to charge a mortgage payment t.
Disconnected the fuel line at carp and cranked the engine for 10 seconds… I got 6oz of fuel in a water bottle, so it seems the pump is working. Changed the fuel filter, and let the engine come up to temperature. Tried driving, and same thing, made it about a mile. Engine is getting pretty...
I’m priming the carb by removing the fuel line coming from the fuel pump, pouring a small amount of fuel in the primary side of the carb and cranking the engine. It takes about 10 seconds for a 16oz water battle to fill with fuel at that point.
I replaced it prior to replacing the fuel pump; I can get another one tomorrow and try that out. Would that cause there to not be any fuel visible in the filter? I replaced the fuel filter with a clear one.
I am still very new to working on cars, so Posing a question to the group… I have replaced the fuel pump, fuel line, gas tank and carburetor on my 71 40. Weber carb, OEM fuel pump and gas tank. Running all soft fuel lines current, it they are new. I can prime the carb and fuel pressure is...
Mine is a 71 with the long jump seats. I recently acquired a SOR Sport bar as well, so trying to fit the two together. They don’t have any sort of instructions they ever put together though.
Does anyone have pictures of installing the SOR jump seat bracket kit for early year FJ40 with a roll bar? I’m trying to do the install and they’re not much help at all.
Can you install these with a disc conversion? I am new to the cruiser world and working on cars, so I am a novice at best when it comes to these types of questions. I am however, in the market for course(6 spline) locking hubs.