Did you have any luck finding the tool or separating the auto timer from the pump. I’m about to take on the same job and wondering how you went.
Any help would be great
1989 HJ60 LS CONVERSION
I’ve got a 1989 hj60 that I’m wanting to do a 6 litre LS and auto conversion on.
I’ve never done a conversion using a motor/trans with computer management.
As I’m wanting to do 99% of work myself. I’m looking for any helpful information from people that may have...
I’m having the same issue now. So wondering if you got them all out using the hydraulic lifter tool with the slide hammer?
Can you please let me know asap?
Cheers
STUCK LIFTER
I have an old diesel engine that I’m changing the lifters in. I have changed all except 1. I’ve looked everywhere for a removal tool but can only find them for hydraulic lifters. As this uses solid lifters I’m a bit stuck. So wondering if anyone may have a trick to removing a stuck...
I have an old diesel engine that I’m changing the lifters in. I have changed all except 1. I’ve looked everywhere for a removal tool but can only find them for hydraulic lifters. As this uses solid lifters I’m a bit stuck. So wondering if anyone may have a trick to removing a stuck lifter...
Hi mate
I’ve read your whole thread as I have the exact same noise in my 1989 2H. I have replaced everything except lifters. Just wondering if you replaced lifters and ended up finding the noise?
If you did solve the noise. Could you please tell me what it was?
Any information would be...
That has crossed my mind as I took it for a drive down to the next town earlier. That’s about 35km away and the noise was there but didn’t affect the motor in any way.
I’m thinking it may be something in the bell housing but my clutch is fine. Maybe a spigot bush. So I’ve just ordered a bore...
I guess I can crack one injector at a time and see what happens.
I’ll give it a go tomorrow when I have time.
If it was a pin it’ll be there the whole time. Not come on as the motor gets to temp.
Cheers
I forgot to mention that I’ve done the valve lash twice since I noticed the noise. First time I noticed that the very first rocker had no adjustment left. So I ordered new rockers and new push rods incase they were bent. After changing them all over all the old gear looked fine and the same...
The noise slowly gets worse until operating temp but yes does care through the rev range.
I have tried the garden hose but all sounds the same.
Other then stripping the motor which I can’t do here. I can’t find anything.
Thank you for your help and would appreciate any other thoughts may...
The injectors have near 100k km on them.
I’ve recently looked in to getting them done but want to be sure of the problem before I keep spending.
I understand what your saying but wouldn’t an injector noise be the same from start up and go up and down with revs?
The noise slowly gets louder...
1989 HJ60
Just after Christmas I took my daughter away camping along the west coast of South Australia. While away I started to notice a faint noise that sounded like a leaky exhaust manifold gasket. Though I couldn’t see any signs of it leaking. To make sure I replaced both inlet and exhaust...
Everything on the whole brake system is brand new. I’ve bled it and have no air.
Tomorrow I’ll re check the booster pin and the rear drums are adjusted correctly.
I know it’s not much. Just something I’ve over looked but don’t know what.
Thank you for the check list. Much appreciated
I have a 1989 hj60 LandCruiser. I have recently replaced all the brakes with brand new components (all 4 corners). I have also put in a new 80 series booster and new master cylinder. Since doing everything I haven’t been able to get my pedal right again.
when the car isn’t running I have a good...