Ok, how do you feel the qua
What do you think of the quality of the door materials? The Toyota/Lexus steel is way thinner than what I‘m accustomed to with German or British vehicles so if it were to get thinner I’d be concerned.
I'm running a 305/50r20. Not my choice for wheel, would have preferred tall skinnies on 16s, but as options for purchases weren't good in 2021, I got what was on the showroom floor and they built for a mall crawler. That's the kind of cutting and panel beating needed to stop the rub plus a 1...
I've got the SPCs and figured that would be the next move, thanks for the advice. Needed an alignment anyway after pounding over the rocks this past weekend.
I would say you could strap around the member that goes from the slider to the frame and pull with no issue. There is plenty of room at the attachment points, but there isn’t enough room between the slider and the cut factory step as it drops into the pocket in the slider.
Used the sliders this past weekend at Merus Adventure park, they performed as well as expected with zero flex or movement. Unfortunately, the wheel and tire combination I purchased the vehicle with is just a bit too wide and rubs the front corner of the slider (and inner fender) when the...
For me it was less about the aesthetic than about the protection. Just so happens that they have a really nice pocket for the cut side-step to drop into yielding a clean look and hiding things if you slip when cutting. I will also say the treadplate is very grippy and far less slippery than...
So I had the exact same issues with pulling from day one and it made it very tiring to drive. Multiple alignment checks all said things were spot on, but finally took it to a good shop that understands the needs of those who modify and they told me KDSS spacers and the Panhard relocation...
I've seen many of the other sliders out there and they all looked a bit unfinished with many stopping short of the front of the rocker by a couple of inches. Knowing the way I wheel my trucks any gap was unacceptable so in researching the Expedition One sliders appeared to offer the most...
Tire is still hanging off the door since beginning of October and has not impacted anything (hinges, door metal, etc.) even after some rough road running. The prado 150 runs a rear door mounted tire carrier from the factory and uses what appear to be the same part numbers for the hinges so...
I have the Toytec with 20” fuel wheels and 32.7” nitros on my GX (purchased that way from new from dealer) and all I can say is that it drives like a Cadillac, soft, but not floaty like an old caddy. Super smooth and in my opinion, it may be too soft as it dives more than I would like under...
Not the intended party, but I mounted my JW carrier about 2 weeks ago, and can only speak volumes about the quality and ease of installation. There are no vibrations or noises associated with it being on the back door either. I have to agree that it doesn’t significantly impact rear door use.
Has anyone yet determined if the parts will work on a 2020-21 GX? I would have had to buy the "luxury" model to get the features and I didn't want the rear air suspension, but would like these features.