I’m in the middle of replacing my rear ambulance door bottoms and am trying to come up with a way to do the bottom & side’s fold over seal. I’ve got the outside’s of the doors replaced and am very close to being ready to put the insides on, but I need to figure a way to pinch the outer edges of...
Would any of you guys have a measurement from the top of the rear bed to the top of the wheel well, as well as the front on the bed, before it slopes downward for the heater? I’m replacing my bed and my drawing of the measurements was used by one of my employees to write down part #’s, not...
Is there a way of telling if this is a South American 2F? The serial # 2F 071509 shows it was built in 12/75. Shouldn’t it have a oval air cleaner set up? If so, is there any differences beside the air cleaner?
I’m in the process of replacing my ‘78 rear bed pan. I have the original one cut out and am in the process of fitting up the new one I got from CCOT. Does anyone know what these 4 screws are for. There is a nut welded on the bottom side of the tub, from the factory. The crossmember that they are...
I just ordered some replacement patches for the bottom of my passenger door and the bottom of my rear ambulance doors, and I was thinking about pouring Eastwood’s rust encapsulater down in the panels once I got them welded up. Pour it in and slowly rotate the door around as to coat everything...
I have a 78 40 and what I believe are the original front fenders, but am curious and have a few questions. Why is there a different support under the turn signal light for each fender? Why is there nuts welded on the driver side fender and threaded collars with flat plates on the passenger side...
I have a ‘78 FJ40 and am in the process of ordering some new pins. I got the shorter bottom pin out this morning with a little persuasion. Once out, and after looking it over, I think there was a spot weld on the bottom of that pin, but not sure. The longer upper pin isn’t so easily persuaded. I...