Not sure what clips you are referring to? No need for a stapler. Just a sharp razor is all you probably need if you don't want to cut with just a soldering iron. Once everything is cut to size, the trim pieces neatly cover any edges.
Tip: The carpet with the mass-backing will not fit exactly...
Ace Hardware usually has a pretty good selection. Just let them know you're trying to size the bolts to your vehicle and test hardware until it's what you need.
I replaced the distributor ~10 months ago on my '94 fzj. During that process I removed the plastic clips that held the spark plug wires to the distributor as they were brittle and warped. Fast forward to yesterday when I had a sudden loss of power on the highway because my old oem wires...
Simple answer, yes. I poured over a lot of information before choosing my setup and reached out to the vendors specifically to confirm my understanding. The swaybar extension brackets have a note on the vendor's website describing where to look for the attachment to the frame. There are...
You don't need the airbags and the variable rate taper coils are more expensive than the linear.
You might want to note my setup doesn't maximize the travel I could get out of the springs - that would require panhard rods, extended brake lines, trailing arms, etc. I'm just cutting my teeth on...
Mike at Exit Offroad and I exchanged some messagess on the Dobinson options. Below is a copy and paste from his email that seems relevant to your desired setup. This is actually what I ended up ordering but have yet to install (arrived today).
So here's the list of parts with the 2.5" setup...
There are not. You will have to use your old carpets as a template. The most common method seems to be as follows:
1. mark the holes with chalk
2. use a torch on a socket about the size of the hole and use the heat to cut the carpet (it will likely ruin your socket so get one you're not...
Mine just came in today - grey '94 interior. I didn't see any other pics posted on mud for this interior so this was a roll of the dice. Couldn't be more happy with the quality and match. I'll post some pics after the install in a few weeks... waiting on some electronics to come and get that...