My '06 LX has a front bull bar (no winch), sliders and drawer system in the back. I don't usually pack heavy and it's typically two adults and a dog in the back. Suspension is AHC with King KTRS-79 coils and AHC torsion bars. I checked my AHC pressures yesterday and the back was 5.7 MPa (well...
Any real world experience on best springs for a 100 series with a front steel bumper, sliders and drawer system (with some tools). I don't usually carry passengers in the back and this is a semi-daily so looking for something that's not going to compromise comfort too much. Would OME 2860 work...
I'm trying to change the body mount behind my driver wheel that's shot. I need to loosen up all the body mounts on the car. Anyone how to access the second from the rear body mount (#6 below)? All the other ones are accessible but I'm stuck on this one.
I'm getting intermittent pop/click sounds coming from underneath the driver seat/footwell when turning the wheel (particularly going over uneven surface). I had initially thought it was due to worn steering rack bushings after seeing they were pretty worn. I just replaced the bushings but that...
So my steering rack bushings are shot. In my attempt to replace the old bushings, I'm stuck trying to remove the metal sleeves (got the inner rubber bushing out). I have tried cold chisel and air chisel together with PB blaster and even put a small hole in the old sleeve (see picture). The...
I bought these a few months ago for my 100 series but just realized these are for 1998-2005, mine is a 2006. Willing to let both go for $80 shipped in CONUS, brand new in box.
Anyone know of an aftermarket light switch that'll fit into this blank cover for offroad lights? I know I could drill or cut but figure I'd ask the forum if someone has found a more elegent solution for this.
Thinking about picking up a set and saw they offer AHC and no AHC versions. My car currently has AHC., if I decide to rip it out later, would I just purchase new mounting hardware from them for that to work?
Any one know what M14 bolts would work for Ironman recovery points with Ironman bumper? The ones that came with the recovery points are too short (likely meant for stock bumper setup) and the ones that came with the ironman bumper don't have threads going all the way up the bolt and there's too...
Edit: decided to install my Ironman bumper so brush guard will be coming off. The brush guard is in good shape overall, some minor paint peel that I touched up, very little rust.
Free for pick up. Located in Northern NJ
hey guys, I started getting an engine whine yesterday that hasn't gone away. It whines at idle with the pitch getting higher on acceleration and I also noticed some tone change when I cut the steering wheel. This actually happened earlier in the year but quickly went away so I didn't bother...
Anyone know of a good shop in north or central Jersey that's experienced at installing aftermarket bumpers (ARB, TJM, Ironman etc.)? Also any rough idea on installation cost? Thanks
Hey guys, I tried to change the transmission fluid today and made a couple errors (should have read up on the forum before hand). I drained the pan without unscrewing the fill plug above first (forgot that 06 doesn't have transmission fluid dipstick and you have to add fluid through the fill...
Hey guys, I wanted to change out my fog light bulbs with some new ones and what should have been a 5min swap has turned into an hour ordeal with no resolution. My passenger side cap came off with ease but driver side cap seem to be stuck. I tried twisting as hard as I could counterclock wise and...
Hi guys,
New to the forum. I'm currently shopping for a 200 series (LC or LX570 2010-2015). I came across a 2011 that seems to be in decent shape with 75k miles. Owner sent me a couple underbody pics but appears to have been coated (looks like spray paint?). Not the greatest pics but any red...