So ….. started some work on my FJ40 and I replaced the alternator with a new one as the old one was looking…. Well…. Really old and not charging .
Got it replaced and was charging fine ( 13.7-14.0 Amps ) for a few weeks then I noticed yesterday it wasn’t charging. I could tell as my 30 amp...
Buddy’s 73 needs a new one and it’s a discontinued part so not on any of the part websites or eBay. Anyone have an idea of one that could be substituted that would use possible work with some of the mounting holes
Here is the part … the hose is cover the top left hole
I currently have a set of Corbeau seats in my FJ40 and was considering going back with the original style seats. I think I have most of the needed parts ….. although the bottom pans probably won’t make it and might cause me to get tetanus shot !!!!
Does it look like anything else I’m missing...
I did a search but couldn’t find a thread on this. Now I probably overlooked it and if I did I’m sorry.
I need to remove my window frame to replace it with a new one. I’m hoping I can losen the the FRP top enough to fold it out and put the new one in.
Anyone got a nice step by step to all the...
Doing a little TLC tonight and noticed the ground strap…..well ain’t doing it’s job !!! 🫤 I looked but couldn‘t see where the heck this thing was supposed to be grounded to. Can someone point out the other end attachment location and I would assume a thick piece of insulated wire ( like a...
Ok…. This is a long story with a lot of bad luck but definitely more stupidity on my part!!!!!
I have a 1995 FZJ73 with a 1FZ 4.5. She was originally carbureted but I have been running a Holley Sniper System with ejected fuel pump for sometime with great results. I’m posting here in the 80s...
So got around to extending my diff breathers into the engine bay firewall. It got me thinking about the transfer case and tranny.
I found this breather on the front right of the tranny. I followed the hose to the rear of the transfer case. It seems they may tie into each other on top of the...
I’m running a 15 x 8 steel wheel with 3.50 backspacing on my series 70. I added a 1” spacer as I had room in the fender well to get the stance a hair wider.
I’m gonna order a new set of steel wheels to get ready of the spacer. Am I correct that if I ordered the same wheel with a 2.50 backspace...
I decided to replace my rear shoes and front pads. I ordered all new shoes, springs, and wheel cylinders. My drums looked pretty good on the outside but they fought me like crazy to come off. My passenger one was almost perfect but my driver side had a slight groove so I’m getting them turned...
I know this isn’t a common setup on here as they were only used for a limited time on the 70 Series out of Colombia and Venezuela. I’m trying to determine the spline count on the axles that are run in these.
Any help on this info will be greatly appreciated!!!
MM
Going to have some work done on my windshield frame and was looking to see what a new one cost just see what’s the smartest route to go. My vehicle is. 1995 FZJ73 with a FRP Hardtop out of Colombia.
I found 2 part numbers that match my VIN number but not really sure which one is correct...
Can anyone provide the correct part number for the ARB Safari Snorkel that fits a 1995 FZJ73 with a 4.5 Gasser ( 1FZ-F). I believe it is SS75HFE.
And who might have them in stock.
Thanks
I’m going to replace my shocks all around on my 95 FZJ73. It currently has the factory shocks and steering stabilizer. All I’ve added height wise is a 1.5” shackle lift. Can anyone give me some aftermarket part numbers to look at. I really don’t need a high end off-road shock just a good one...
These look to be approximately 16 x 8” wheels with how deep the dish is.. Definitely look much wider than the standard 70 wheels you see of 6.5” or 7”. Any idea on the manufacture of this wheel and where they can be purchased?
This is on a 70 Series 1FZ-F. Most of the 70s on the 70s Forum are diesel so that’s why I’m posting here for some carburetor expertise.
I recently started having an initial hard start after sitting for a few days. I thought it might have been from water getting into my tank after some...
Found a few of my gas tank hose were not connected and a few nipples on the tank are missing hoses. This thing is a bundle of snakes from the filler neck to the tank!!!! Before I start plastering pics of what I’m seeing, I was hoping someone had a tank / filler neck diagram of the hoses and...
I have a 1995 FZJ73 with a Dana 60 Differential in the rear. I want to change the fluid and replace the rear cover with one that has a drain plug for easier fluid changes. My question is does this require an additive for the limited slip? Does the below gear oil have the required additive...
While this carb is on a 93 FJ73, I posted here as most of the 70s in the 70s forum are diesel And the 3F was in the 60 series.
My friend has this vehicle and we want to purchase a China carb while this one is sent off for rebuild. All the 3Fs carbs I’ve seen on eBay are slightly different then...