I have one OEM 18” wheel off a 2007 LX470 for sale.
I had purchased this wheel used to replace, what I was told to be a bent wheel. The tire shop had issues balancing my original wheel when I replaced the tires, so they suggested making the problem child my spare. I intended to rotate in my...
I wanted to leave this thread with my solution for the next person with this issue.
Unfortunately, I was not able to solve the question of the P0016 and P0018 codes. I was running short on time, so I decided to tear back in and reset the belt. I believe I followed the same steps, but low and...
Bump
Anyone with 2006+ VVT FSM access want to take a look at these codes?
I may just have to tear into it again if i can't get anywhere with the codes.
I just finished up my 90k service on my 2006 LX, and I am throwing P0016 and P0018 engine codes. I completed my service with the 2004 FSM (along with some helpful tips from others that had done VVT timing belt replacements) but the 2004 FSM does not list the P0016 or P0018 codes as I believe...
The lowers gave me the most headache as well...
After breaking 2 on my first shock change, I went for some heat. The bottom bolt seemed to break very easily for me, so be cautious and patient. The penetrating oil will need some time to get into the threads as they go fairly deep. Drilling out...
I'm looking for a 2000 - 2003 Tundra FSM, and it looks like the TTORA original link has been taken down.
http://www.ncttora.com/fsm/index.html
Anybody know a new source for the PDF version of the manual?
Thanks for the help.
I had a failed crank in a 3FE. The general consensus was that it was not worth repairing, so I searched for a used 3FE in running condition.
I was able to find a rolled truck about 7 hours away, drove down, picked up the motor, and installed it.
I was able to get the motor for less than...
I just completed a full bleed on my 80 after replacing the rear calipers and seeing the nasty old brake fluid.
The two person method was very effective, and the brakes feel great.
I believe you have a missing tooth on the lifting mechanism.
The motor and the auto stop are likely not the culprit, but rather that the last tooth is damaged on the lifting gear so the window never hits the true top of the range to cause the motor to reach maximum torque.
I had this issue...
I just switched to the DT from a Dunlop highway tire on my 100, and the road noise is not as bad as I would have expected. For the aggressive look of the tread, I would have expected more road noise than I get. They seem very quiet to me for the type of tire they are.
When I switched from...
Where are you located?
I have a stock front bumper from a 94 that is in good condition in Minneapolis, Minn that I believe will fit.
Its not new, but it could be a good replacement. It would look great with a little cleaning. It was removed for an ARB.
I can send pics if you're...
Received my LEDs yesterday and was able to get the domes in right away.
Well packaged, and very fast shipping! LEDs fit and work great.
Thank you supercarrera!