the throw out bearing should go into and depress the splines on the clucth plate. it didnt look like yours was going in enough? or am i seeing it right? you typical can tighten the linkage to make the throw out bearing go in more or get or make a longer adjustment shaft
Has anyone tried to just shim the stock steering gear box out a little bit by welding a 1/4 inch or so steel plate between the frame and the stock steering gear box? Does the stock steering shaft have a little play side to side ? I dropped in a 5.3 v8 chevy vortec in my 1976 fj 40 and the LS...
Passenger side a block hugger from summit like figure a drivers side from speedway motors like figure c I think it’s going to fit I loosened up tge motor mounts and scooted tge motor as far as it would go to Tge psssenger side and I’m going to tilt it a bit higher drivers side lower passenger...
Im lookin at it and it looks like i can only shim it out a small amount which i dot need much? otherwise the linkage will be to close to the shock 1/4 in shouldnt mess the linkkage much??
I got a 1976 fj 40 I need just a little more clearance for the exhaust manifold. v8 conversion. Is it possible to shim out steering gear box? does The shaft have enough free play to put a 1/4 inch plate or more??? between the steering gear box and the frame?
Engine fuse in the box ? You mean the fuse block next to the drivers left foot vent door tgst a pain in the back to get to ? I checked those I forgot about the little black boxes fuses next to tge radio ?
Whole Motors s 5.3 Vortec out of a 2002 Tahoe so I should hook tge white blue strip negative side to tge big post bsck of Chevy alternator and tge positive side white green side to tge 12 volt side of tge two little wires? I think the alternator had one little wire as battery voltage and the...
Well the hot side of the ammeter is still hot still no power to tge old fuze block didn’t see anything melted the ground side of the ammeter is cold and disconnected I didn’t check it for juice before I disconnected it I thought it was a ground I bet it was supposed to be hot ?? It’s white blue...
Flowtech 11730FLT LS Swap Exhaust Manifolds, Natural Cast Finish
Part #: 72211730FLTQty: 1 @ $ 225.95 each supposed to fit under 3 inches for the tight drivers side
$ 225.95
No the alternator isn’t stock it was charging at about low 14 volts before I smoked it will look for melted wires probably in week my next day off. it did sound really good. another exhaust manifold on order yuck. I took the entire motor out of a 2002 Chevy Tahoe 5.3 Vortec gen III I think. The...
I hooked the old alternator wires back up to the new altnator white blue strip and white green strip i cant rember 3rd one gauge still not working I disconected it shut it off took a break capped off wires everthing seemed ok ? came back and nothing will look later f
well it show a hair of discharge when you fire it up but it not working not moving after you fire it up altenator charging but I did put a new chevy 5.3 in it trying to get the gauges to work. well sht I f something up where does it melt the harness under the dash? quick look didnt see anything...