I've so far been unable to get my secondary to open.. I rebuilt my carb ~1,500 miles ago, did a good job, made sure all the vacuum passageways were open, and of course installed a new secondary diaphragm. However, I found that the secondary was not opening beyond the minor amount initiated by...
I just installed an H55F and rebuilt my transfer case.. Prior to this I never paid any attention to the temp of my old units.
Now, as part of ensuring everything is working properly, I've been checking the temp with an IR thermometer.. I notice my transfer case and transmission are usually...
I'm hoping anyone with some experience might be able to answer a few questions and provide some guidance.
I've taken the body off my FJ60 and am in the process of wire wheeling off all the existing undercoating and rust.. Getting it down to bare metal and a few patches of well adhered factory...
I'm trying to find a good set of the rubber grommets that go in the fuel line clamps that run along the frame rail.. The clamps and grommets all seem to be NLA so I'm getting my clamps re-plated. But, my grommets are falling apart.
Does anyone have a good, usable set that I can clean up?
Anyone know where I can find these insulators? They seem to be NLA from toyota and I can't find an aftermarket part anywhere. Seems like this should be easy to find???
Looking for the splash/heat shield thing that mounts to the frame below the steering shafts in the FJ60 engine compartment. Doesnt need to be mint, but good enough to rehab.
here's a pic of mine I took off:
Howdy.. I'm looking for help here.. I need to address some patches of surface rust on the bottom side of my truck. I've got the body off and on blocks and am ready to go to town.
But, the factory undercoating is showing itself to be SUPER resilient. I don't expect this to be an easy job, but...
Pretty much the last parts I need to source or refurbish for my frame-off restoration are the fuel and brake line clamps and grommets that are used throughout the truck. Online sources say these are either discontinued, or no pics are available to verify what the part number represents. While...
Ok ok, I know similar questions have been asked a million times, BUT they havent been asked exactly like this AND everyone seems to love talking about it...
I've got my diffs, axles, etc all torn apart now in preparation for powder coating as part of my frame off. I'll be replacing all the...
I need a new suspension setup and tires and I think my preference is 31s and stock height springs instead of the standard 2-3" lift with 33s.. I'm not expecting to do a ton of off-roading that a 60 with 31" BFG K02s cant handle. And, loading kids into car seats in a lifted 60 is kind of a pain...
I've got a lead on a frame for an FJ62 in Oregon City, OR and need it here in Bend. Anyone got a trailer and want to come over the mountains? This would be a bare frame and help handling it is available on either side of the journey.
Thanks.
Looking for a hopefully rust free frame for an FJ60... Hopefully in or near Oregon. Please let me know if you have one or might know someone who does. THX
Fabric is in great condition, no tears, stains, etc... Rear trim pieces could use a repaint. $250 + shipping seems right.
I also have a full set of rear FJ60 belts if anyone is interested.. Possibly front too.