Search results for query: *

Forum search Google search

  1. EsbenDenmark

    Swivel hub bearing feels worn but is new??

    Just a pic for reference
  2. EsbenDenmark

    Swivel hub bearing feels worn but is new??

    The whole truck has only done 45.000km in total When I took our the old bearing I could not feel any wear at all and nothing visible
  3. EsbenDenmark

    Swivel hub bearing feels worn but is new??

    1995 hzj75 Last time I installed new wheel bearings I also changed the top and lower swivel hub bearings but did not change the shim.. And I did NOT test the swivel "turning" preload So now after 10.000km I wanted to check and it was way too loose.. only about 1.5kg resistance. And there was...
  4. EsbenDenmark

    Signs of worn differential?

    Thank you for your responses. I will just put it back in with new oil and not think more about it!
  5. EsbenDenmark

    Signs of worn differential?

    I did find these that was stuck on the inside where they drilled holes for the 8mm bolts.. Surprised they did not remove those at the factory
  6. EsbenDenmark

    Signs of worn differential?

    Oil looks pretty good. A bit of dark stuff but nothing larger than fine dust. Oil has done about 10.000km
  7. EsbenDenmark

    Signs of worn differential?

    I just pulled the front differential on my 1995 hzj75 as I have a leaking seal. But now I see these little flakes on some of the edges of the ring gear and pinion gear.... There is also some very fine metal shavings stuck on some parts and there were fine metal dust on drain plug magnet...
  8. EsbenDenmark

    Dead swivel hub bearing after only 10.000km?

    I just pulled the axle as I need to change the diff seal. I can feel a slight difference in resistance when moving the swivel hub from center position. Definitely feels like a worn bearing. But I did full swivel hub rebuild only 10.000km ago. I did however not set a high enough bearing preload...
  9. EsbenDenmark

    Resistance when blowing into diff breather??

    Yes I have a OEM breather and it is almost new and relocated to enginebay. Is totally clean and never been even dusty 👍
  10. EsbenDenmark

    Resistance when blowing into diff breather??

    I am having a leak in my front differential and I am wondering if it due to too much resistance in the diff breather. I have installeret a original diff breather but I was surprised to feel quite a bit of resistance before I felt the little diff breather "open up" (blowing air into the tube like...
  11. EsbenDenmark

    Rear sway bar for hzj75

    Let us know how it works out for you.. and if you can feel a difference.
  12. EsbenDenmark

    Rear sway bar for hzj75

    Hi. yes everything is from OldManEmu The mounting kit is called FK77 (about 200 euro) and the sway bar is called OMESTAB9 (about 450 euro)
  13. EsbenDenmark

    Rear chassis crossmember strength??? enough for a recovery point?

    Sounds like I should probably replace the rear Cross member with a new square tubing.
  14. EsbenDenmark

    Rear chassis crossmember strength??? enough for a recovery point?

    Homemade tow point at the rear of the HZJ I am thinking about making a rear recovery point on my 1995 HZJ so that I can be pulled free when I get stuck. So it must be strong!!! I have removed the towbar so I was wondering if I could bolt an eye to the middle of the chassis frame where the...
  15. EsbenDenmark

    Design ideas DIY rear recovery points for HZJ75

    Mmmh there might be something about it. You are not the only one suggesting to extent the bracket. I guess I will go back to the drawing board and make a few changes.
  16. EsbenDenmark

    Design ideas DIY rear recovery points for HZJ75

    Hi So I am designing a couple of rear recovery points for my HZJ75. I am planning to cut a piece of 15mm stell with a oval hole for the shackle but there will still be 20mm of material around the hole. the cut plate will be mounted with 2 8mm bolts through the frame + 2 bolts to the bracket for...
  17. EsbenDenmark

    Rear sway bar for hzj75

    Just wanted to share a quick update. I got a sway bar kit from Old Man EMU for the first 79 series. It fits perfectly and a direct bolt on! Also I does make a difference when cornering.
  18. EsbenDenmark

    Recovery Point for hzj75 not fitting

    I just received a pair of Roadsafe tow points for the 75 series. They do not fir since the parabolic leaf springs are apparently a bit longer than the oem springs.. This video is my description of my little issue. This video shows the nut getting very close to the tow point. And that is just...
  19. EsbenDenmark

    Anyone with a 78 (2001-2007) or 79 series (1999-2007) that can measure a few things for me❓HZJ75 rear Sway bar project

    After adding a camper on my 75 series I really want a rear sway bar. Unfortunately none was ever made for the 75 series so I am hoping one from the 79 series can be adapted. Have anyone done this or had the idea? Is it even possible? So can someone measure the following (please see attached...
  20. EsbenDenmark

    Rear sway bar for hzj75

    thank you for the part numbers. I am sure I will be able to find these at some point. Is there anyone who is able to take some pictures of their own 79series on how the bar is mounted on both the axle and on the frame.. the more pictures the better. also I need some measuments on there the...
Back
Top Bottom