Got this yesterday...cleared the code. Back today.
Shift solenoid E; No info online pertaining to 100's directly. Truck goes about as it always did, which is to say that without the dash CEL, no indication of abnormal behavior.
TIA and Merry Christmas
Does anyone know the hardness (rockwell) of the Hub drive flange and that of the axle splines? I'd love to know if the flange is weaker than the axle splines or vice versa and, if there is play, where it could be concentrated.
Thanks
I need the following Toyota PN's for:
-L/R Motor Mounts
-Trans Mount(s)
-Oil pan Gasket
-Rear Main Seal
Long story short, I picked up a pretty good leak recently...about the size of a quarter every day on the driveway. I took it to the shop, and they cleaned it and feel that it's very likely...
Looking for the person/shop that can look after the things that I am not wanting/willing to do... Specifically headliner removal and sunroof repair. I've sprayed enough SiliKroil to know that just cause it works today doesn't mean it will work tomorrow.
Who is the Toyota guy/shop in southeast...
In the process of cleaning my 1998 193K LX470 throttle body today, I noticed that my throttle cable (when applied by an assistant in the cab) was not "opening" the throttle plate to its stopper. I was leaving about 10 degrees of throttle plate travel on the table. I adjusted the throttle cable...
I recently had front SPC UCA's, whiteline steering rack bushings, toyota rear upper UCA's, and SPC rear LCA's installed and the truck pop's/bangs on sharp hard right or left turns (especially from a stop) in a way that it did not before the work. The shop that installed the parts does not...
For my 1998 LX470...
I bought a set from a member here and all is well. Unfortunately, the set did not come with instructions for mounting the front machined spacer. I tried to install the fronts this morning and, no matter how i clocked the spacer, it would not sit flush on the hub/rotor...