Hi guys,
been on the forum on and off over the last couple of years, previously I had an LJ78 landcruiser that i did a few engine mods on, most notably the Holset HE200 turbo Conversion. I have a post in the forum about that. Since completing my apprenticeship as a diesel mechanic, i decided...
Hi all,
Have done the cambelt on my 2lte, everything went smooth. However, after doing the two engine rotations and locking the idler I feel as though the belt is to loose. However I cant find any information on how tight it should be. Has anyone else done the manual process and found the same...
Is this the original glow plug insulator? And does anyone if there's suppost to be one on the bottom of the intake manifold where those two wires go? Dropped off the side of the block and onto the floor when I was shifting the harness.
Hey Team,
I've removed my intake manifold and entire EGR system. Just wanting to get rid of that idle VSV also if it's not important, just wondering what components have to stay and what ones can go, and upon removal if anything needs blanked.
And also what's that vacuum diaphragm for on the...
Fuel Cut Defencer | ELECTRONICS | PRODUCT | HKS
This is a voltage clamp for a MAP sensor. You wire it into your map sensor, work out the voltage of the signal just before 14psi and the clamp will prevent the signal from increasing. Therefor you can run as much boost as you like without the...
Allright guys,
Over this past year I have been reading up on this forum for different tips and tricks to gain extra power out of the 2LTE and thought i would share my experience, as I haven't seen it been done on any of these related forums. I obtained the truck in February, and in the saddest...