I have the same radio and used this. I wanted to keep both sockets so I just drilled a hole in the panel in between the sockets.
https://www.amazon.com/gp/product/B07QJV1YQJ/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1
They made an annoucement on their Instagram the other day. It's for the month of November I believe.
20% off: Blacknov20 First 5 orders,
15% off: Blacknov15 First 10 orders
10% off: blacknov10 First 50 orders
I just checked and the 20% and 15% off codes don't work anymore.
With the current version of this overhead console mount, I estimate you lose about 25% of rearward visibility. Now I already have a rear shelf mounted to my rear grab handles. So, my rearward view was already obscured. In my opinion, it's worth it for the gain in instant information.
I had a ScanGauge II installed in a mount in my overhead console. It worked great and provided all the information I needed after I had sent in back to the Manufacturer to get the latest firmware and programmed in the correct x-gauge commands for my trans temp and TPMS sensors. The only...
Recently I noticed air, hot or cold, wasn't blowing from my center vents flanking the radio. Air flows great through the outboard vents. I confirmed my vent flaps were open. So, I removed the driver's side vent to find out what is wrong. It appears the internal flapper that I believe either...
The route mentioned above is definitely the best way to go if you can. But if you can't for some reason, try adding a drip loop or two to prevent water from running into your rear hatch area. I didn't add a drip loop to my GMRS antenna cable when I initially installed it to a bracket that mounts...
What you're describing is certainly doable. My friend built something similar for his rig. However, I recommend looking into either an SPOD as mentioned above or a Switch Pro if you're not fully invested in a DIY solution. I personally have a Switch Pro which keeps all of my power and ground...
Clever idea putting the electronics in a pelican case! What size case did you use? I picked up the same winch today and hoping to install it this weekend.
Your rig looks great! Which STEDI lights model and size do you have? Where did you get them? I'm hoping to have pretty much the same front bumper/lighting setup as you. So any feedback is appreciated. Feel free to message me privately.
That Dissent bumper looks amazing! It's so temping with the sale they're running this weekend. How easy is it to remove the bull bar? Can it be done without uninstalling a bunch of parts? And I noticed you're running Diode Dynamics lights instead of the Rigids I normally see. Did you have to...
I bought this to mount my switch setup. Due to the higher underhood temps, I'm not sure how well the box would stick to the factor fuse holder.
https://owlexpedition.com/collections/100-series-land-cruiser-lx470/products/100-series-land-cruiser-and-lx470-accesory-tray