Hey all, few quick things
This afternoon I decided to finally swap "Solenoid E" from the p0770 code. Dropped the pan and found a substantial amount of metal in the bottom of the pan on the magnets. Now, I am unsure the service history on my rig, but the pan looked as though the fluid has been...
Well when rock auto sends you four parts and 3 of the 4 ship broken I have a bit of an issue. But thanks for the advice. Looks like I’ll be pulling these out and slapping some new ones in.
I used delpho brand. Unsure they were a rock auto special (last time buying from them) And I did grind about 2mm from the bottom of the stud. They still seem pretty close to the wheel. But I do have a bit more to grind before I come close to the cotter pin hole.
Hello all,
So I just finished replacing several front end parts, inner and outer tie rods, lower ball joints, new UCAs and repacking bearings. I was just placed the wheels back on and set the truck back on the ground and the studs on my lower ball joints and contacting the inner wheel. Any...
That's a super bad picture. I will link one when I get home that may be better. It sits on top of the brass bushing. Oil seal was the only description I could find in the FSM
Hey guys, I'm redoing alot of the old seals and gaskets in the front end while I reboot my CVs. And just had a question. I cannot for the life of me find a match to what I assume is the old oil seal on the outer end of the CV axle. It depresses in to the spindle. I thought I had found it in the...
Hey guys,
Yesterday morning while driving to work my CEL came on, didn't really think anything of it. Truck has been driving fine, after work went and had the code red and it gave me the P0770 Shift solenoid "E". Prices for the solenoid almost gave me a heart attack. Planning on swapping the...