Search results for query: *

  • Users: jumper
  • Content: Threads
  • Order by date

Forum search Google search

  1. J

    Fuse box and Wiring for a Chev LT1

    I am putting a Chev LT1 in the 40 and would like to see how others have done the fuse box and wiring. Where did you put the fuse box and computer ? How did you distribute power from the battery to the fuse box ? cheers
  2. J

    Lt1 ecm

    Is it ok to put a 95' lt1 ecm with knock module in the glove box of a 40 ?
  3. J

    350 problems

    My chev 350 has some issues Out of the left pipe, lots of smoke a bit of blue, a bit of greyish could be white, a bit of black, all mixed up. At idle and when reved. Out of the right pipe, blueish smoke only visible using a light at the pipe at idle, easily visible when reved. Oil ok...
  4. J

    Holley carb offroad mods

    Has anybody done the mods in this link and did they make a difference?
  5. J

    Holley carb air filter bolt thread size

    What is the Holley carb air filter bolt thread size?
  6. J

    2wd to 4wd switch on a h55f What type?

    Doing a bit of rewiring in the 40 due to random wires all over the place and the fact that one unfused live wire shorted out burnt the insulation off and tried to melt its way into the voltage regulator :mad: had to use the fire extinguisher and cut the wire as i could not get a spanner quick...
  7. J

    Fj55 Front springs into fj40

    Will Fj55 Front springs fit into a fj40 with out to much trouble ? I understand that they are the same length, the center pin hole is centered so they move the axle 1.5in forward is this correct? Are the bushings the same ? Would there be problems with brake lines, steering stuff, d-shaft...
  8. J

    chevy 350 water pump

    Where are the weep? holes on a chevy 350 water pump ? Reason being that when i was finished for the day wheeling i was unlocking the hubs and noticed drip drip drip from around the water pump so i cleaned the mud off the back of the water pump and the drip turned into a small jet.
  9. J

    4wd not working

    The 4wd on my 40 is not working. i hooked the vac line back to the carb flicked the switch with the engine running and no 4wd, then pulled the low range lever back still no 4wd. If the low range lever is pulled back and the manual hubs are unlocked, when the 40 is rolled the front d-shaft...
  10. J

    4wd not working

    The 4wd on my 40 is not working. i hooked the vac line back to the carb flicked the switch with the engine running and no 4wd, then pulled the low range lever back still no 4wd. If the low range lever is pulled back and the manual hubs are unlocked, when the 40 is rolled the front d-shaft...
  11. J

    shackle steel thickness

    What thickness steel should be used for homemade 2.5 lift shackles ? is 6mm enough or do they need to be 8mm.
  12. J

    idle and take off problems

    so i changed to a four barrel setup with a holley 600 cfm carb the carb was setup by a local performance shop. i drove 5 mins to the highway 10 mins on the highway, off the highway the engine dies at the second set of lights 30 sceonds apart. It will start after 5-10 mins but if you touch the...
  13. J

    Do i need a ballast resistor?

    I have a Pertronix ignitor in place of the points and a MSD Blaster 2 coil do i need the ballast resistor ?
  14. J

    Engine dies at idle and splutters under load

    Engine dies at idle and splutters under load it will run on the choke but does not sound right I have checked for vacuum leaks, checked the timing, fuel and fuel filter, fuel lines, coil, leads, spark plugs and dizzy they all seem to be ok. Cleaned the rochester 2bl carb out the jets are...
  15. J

    missing pics

    Has anyone got the pics from this thread in the tech section as they seem to be missing. http://www.ih8mud.com/tech/woody/welded.html thanks
  16. J

    body lift rear mounts

    how do i get to the 4 rear mounts that sit above the frame? are they captive bolts? do i cut the rear floor to get to them ?
  17. J

    new/used alternator wiring

    i want to put a bosch 110 amp alt internal reglator into my 82 to replace the denso 50 amp fork lift alt that came with the 350 in the truck when i got it. the bosch has b+ thick red wire, d+ thin green wire and a square hole with w next to it. the 50 amp is hooked up to the stock external...
  18. J

    chevy v8 forum

    hi could someone point me in the direction of a chevy v8 forum thanks reason being that i just got a 82 fj40 with a chevy v8 and 5 speed that is heavy on the fuel and has a strong fuel smell pics to follow thanks
  19. J

    h55f reversing light switch

    the reversing lights are on all the time, thinking the switch is stuck. where is the switch on the gear box ? i was told the gearbox was from a fj70 5 speed possible h55f????? has anyone got an exploded pic of the top of the gearbox? thanks
  20. J

    New here, axle question

    Hi I'm new here from NZ i haven't got an fj40 yet just waiting for a good deal to come up, a couple of questions. I have an arb locker in a h233b, 4.65, nissan rear axle centered with disks, out of a terrano/pathfinder the same axles are under nissan patrols/safaris. do you think it would be...
Back
Top Bottom