Hi,
I'm trying to remove terminals from this connector. As you can see, I was able to pull the terminal retainer (the yellow part), but I'm not sure if I should be able to remove it fully from the connector before trying to remove terminals or is this enough? I can't figure it out by looking...
Hi,
I have a silly question: how to determine the body mount cushion type for the middle section upper cushion? Like on the image below - highlighted type A, B or C? How do I know which one I should use or I have (except of removing it)?
Hi again,
This time two electrical wiring related questions.
1. According to EWD168F manual diagrams there is something called "Engine Oil Level ECU". It's not a sender, it's an ECU. But I can't find it in any parts diagrams, e.g. here TOYOTA | Japan Parts EU - http://www.japan-parts.eu and I...
Hi,
While removing floor carpet I found out there are these plastic "rails" mounted from the bottom by staples on the front door side edges of the carpet. They go between rocker panels and door scuffs. I couldn't find them on any parts diagrams.
Does anyone know if they are original? Are they...
I'm in the process of rebuilding of front axle knuckles and hubs in my LJ70. Recently I disconnected knuckle arm from tie rod end and during this operation I noticed that some grease leaked out of the tie rod end rubber boot.
Should I consider replacing the tie rod end or try to inject some MP...
Hi,
What's the difference in center console boxes with part numbers:
58911-90K01-B0 and 58911-90K00-B0 ?
They are both bluish gray, one is with heater and the other without. I found some pictures on the internet, but I'm not 100% sure which one it is.
I have a broken console without heater...
Hi,
The 1KZ-T service manual says to do the compression test by plugging into injection nozzle holes. Is it possible to do the compression test by plugging into glow plug holes instead of injection nozzle holes (like it is suggested in 2L-T service manual)? Would there be any difference in...