If you want to sort the logistics i have a brush guard in my garage- New Zealand that I'm happy to sell off.
8/10 condition (one small scratch on it and a paint scuff from something, also small)
Also with fuel up just over half a turn and the bleed off in I’m getting 13-14 psi (was 12 before) will turning the bleed off in increase boost further by altering what the map sensor reads? Or better to just play with the boost tap?
ill let you know how it goes, this is the unit im putting in, Lovato Petrol Shut Off Valve
as it will go in the fuel line before the fuel filter i figure the unit should stop the motor once you hit the switch as there will be no vaccume for the line to keep pulling fuel/ keep the motor running...
In regards to adding to much fuel and having a run away scenario. Is there any harm in just shutting the motor down at this point? after reading that in your last thread im currently installing a fuel cut (similar to what i have used in the past for lpg duel fuel set ups in other cars) so if it...
Thanks Nick,
Out of interest do you know if the current location would alter the gauge much post filter (as it stands without the bleed off). Im away from the truck today so cant test it, but my max reading is currently 12psi with the T in that location, would this actually be higher at the...
Sorry if im being punishing on this.. below ive drawn in where mine is currently and will be in relation to the T that you show to add, should i keep the guage T here or move it to the other spot ive drawn before the filter then?
sweet, was just worried if the two T's are 10-15cm apart on the same line the bleed off would would still effect the line pressure and put the gauge off.
Finally getting ready to play with this on mine, with this though the line you tap into for the bleed off is the same line I run my boost gauge from. Will this still be sweet if I add the valve t in after the guage? Or should I move the gauge line?
Have seen a few people cry about these on other sites in fear of 'loosing there v8's to eco warriors', being that Toyota have a partnership with Tesla id be pretty keen to see one though, especially if they're made in their factory and put to market, Teslas Model X has a range of 4-500km per...
Hi,
Just looking at trans coolers for my lj78.
What size units are people using/ is there a lot of difference/ performance between these size units?
These are the units I'm looking at as i think they will fit well where id like to mount it, thoughts? will be behind the grill and attached...
This is the same as what i installed on my 2lte lj78, i back it as a unit and have found with a ram flow top its made a difference by pushing cool air into the motor, not huge but all things help the big picture.
i got mine from here. they seem to be available from a number of outlets so i'm...
i think the snorkel is a minor mod but ive seen improvements from it. I have read that people think it will give them more hp... that id say is a myth. I always used to have a running temp of 77-82c after doing the radiator, fan and lot temp thermostat, but with the snorkel it dropped to 72...
If your not going to add an intercooler any time soon, a ram head snorkel may help with temps a little also (so long as your happy to drill into the guard and have a snorkel on the truck). When i installed mine i found it helped as the factory intake is pretty restrictive inside the guard. I...
I just ordered a couple of each of the diodes to try out, but if you are doing an order of these put me down for one and id be keen to have a few options to try out, will just need it shipped to NZ though if you are happy to sort that.
Once your doing the orders pm me your payment details and...