Search results for query: *

Forum search Google search

  1. Kfpals77

    1HD-T in FZJ80 - transmission thoughts

    Ah, yes, you're correct! I should have changed the question. I found out afterwards the transmission I received with the 1HD-T is A442F, the older type. Still, I don't like it and I'm trying to figure out if I can use the A442F that came with the 1FZ-FE with the 1HD-T.
  2. Kfpals77

    1HD-T in FZJ80 - transmission thoughts

    An answer to this one would be highly appreciated...
  3. Kfpals77

    Cooking alternator and starter in 1HD-T

    The starter is 24 volt. The alternator wasn't charging the batteries until I connected the 3 pin connector (IG, S, L) on the back side of it. Not sure about the starter relay.
  4. Kfpals77

    Cooking alternator and starter in 1HD-T

    Noted! Thanks :)
  5. Kfpals77

    Cooking alternator and starter in 1HD-T

    #2 I've been studying the electrical drawings too - hoping to gain better understanding of the system before I have the alternator repaired, hoping to find the issue before smoking the alternator again. Is there someone here that could explain the purpose of the 24 Volt Hold Warning Relay to...
  6. Kfpals77

    Cooking alternator and starter in 1HD-T

    Hi all, I have an issue to solve. I had already asked the same question in the 80 Series Tech forum but was advised to ask here. During my 1FZ-FE (out) / 1HD-T (in) engine swap project I have been slowly going through the newly installed old electric system that fits the 1HD-T. During the...
  7. Kfpals77

    Cooking alternator and starter in 1HD-T

    Thanks. Will get it into the diesel section. My guess was the 24V hold warning relay disables the alternator, but I don't know. (About knocking it with a hammer, I was simply following an advise from a mechanic to see if the brush set / solenoids could be stuck. Not deeper than that.)
  8. Kfpals77

    Cooking alternator and starter in 1HD-T

    Is there someone here that could explain the purpose of the 24 Volt Hold Warning Relay to me? It seems to be grounding the Alternator Terminal L. Why?
  9. Kfpals77

    Cooking alternator and starter in 1HD-T

    To clarify - the truck is now able to start with key in switch at "On" position. Any thoughts?
  10. Kfpals77

    Cooking alternator and starter in 1HD-T

    Hi all, I have an issue to solve. During my 1FZ-FE (out) / 1HD-T (in) engine swap project I have been slowly going through the newly installed old electric system that fits the 1HD-T. During the installation, the 3 connector plug (IG, S, L) on the alternator back wasn't connected but only the...
  11. Kfpals77

    Effects of VCT not being installed in 1HD-T ???

    Yes
  12. Kfpals77

    Effects of VCT not being installed in 1HD-T ???

    I'm in the middle of the diesel conversion and the VCT has not been installed yet. I didn't install the engine my self but I took over the project with the majority of parts installed, and the truck started fine to begin with. Starting issues have now been developing in the last few days and...
  13. Kfpals77

    Instrument cluster shows 4x to 5x the actual speed

    The transmission installed is the older (first?) generation of A442F, with hydraulic controls only (not the A440F though). I followed an advise to replace the electrical system too which has now been done, and the truck runs and drives with some few electrical hiccups. It is counting the...
  14. Kfpals77

    Instrument cluster shows 4x to 5x the actual speed

    I've been working on a diesel transplant in my 1992 80 series truck, where an old 1HD-T replaced an 1FZ-FE with broken head gasket. The diesel transplant called out a different wire harness which required a different instrument cluster, which has a cable directly from the transfer case into the...
  15. Kfpals77

    Throttle cable for A440f

    I need to replace the throttle cable (kickdown cable / detent cable) for the older 4 step transmission (with no overdrive), and thought I had found the correct cable on RockAuto. The cable part number is 3552060090, a discontinued part number. Now I have information from a local Toyota dealer...
  16. Kfpals77

    A440f throttle cable

    Did you find the Throttle Cable? If so, where did you find it?
  17. Kfpals77

    No power to lights after diesel swap

    Hi, We're on the last meters of swapping the 1FZ-FE and transmission engine for 1HD-T and older transmission, a path that took slightly different turn than anticipated when we decided we needed to replace the electrical system also. Now we have the 1HD-T and transmission installed, the car...
  18. Kfpals77

    1HD-T in FZJ80 - transmission thoughts

    Hi I'm about to remove the 1FZ-FE and A442F from my FZJ80 to install an 1HD-T along with the older (A440F ?) transmission which I believe I will receive tomorrow or the day after. I'm thinking of the A442F that is currently installed. Has anyone here done the swap but kept the petrol transmission?
  19. Kfpals77

    1FZ-FE blown head gasket?

    I've been having some issues with the cooling system in my 1FZ-FE and just recently had the water pump and thermostat replaced. The system doesn't seem to build up pressure, the cabin doesn't heat and it looses liquid. Would it be possible to have bubbles like those caused by something else...
  20. Kfpals77

    Igniter replacement -> mileage drops to 7.5 MPG

    Thank you all for your input. I really appreciate it. Here in Iceland we don't have so many of the 1FZ-FE LC80s in action, most of them are 4.2 diesel here and hence the local knowledge and parts are not in my favor. Regarding the igniter - as I understand how it works, it sends a signal to...
Back
Top Bottom