Search results for query: *

Forum search Google search

  1. OOCustoms

    1997 mystery cold start issue

    No- still looking. harness turned out to be ok.
  2. OOCustoms

    FAQ 1995-1997 1FZ-FE FZJ80 OBD2 Main Engine Wiring Harness Connector Information

    Ok so I have been following this thread with interest- lots of great information. I haven't had any luck through search for an answer to my question- I have a '97 that has cold start issues. Low idle , stalling, stumbling for the first 1-2 minutes until it warms up- then it's fine. I believe the...
  3. OOCustoms

    1997 mystery cold start issue

    All the sensors that the ECU uses are new- however I think I might have found where my issue lies- I tested the IAC harness for resistance- (3-10 ohms) and it's way out of spec. Looks like I have a short somewhere in the harness between the connector and ecu. ****.
  4. OOCustoms

    1997 mystery cold start issue

    IAC is new- I guess I can test it to make sure resistance is correct, but chances I got a bad one are slim.
  5. OOCustoms

    1997 mystery cold start issue

    Ok- here’s the deal. When the truck is cold started, it fires right up- idle is around 1000. Within about 45-60 seconds it starts to shudder, idle drops very low, engine surges and stumbles for about 60 seconds or so- sometimes stalls, sometimes comes out of it and suddenly smooths right out. If...
  6. OOCustoms

    My misfire thread..

    Bump- reviving this thread once more- I have the same stumbling/surging idle with no power- only for the first 1-2 minutes, only when it's full cold start. After inital stumbling/low idle it behaves fine, it won't do it again until it cools down for quite a while. Did you guys ever get it sorted...
  7. OOCustoms

    Wanted Australian-style FJ80 Headlight Assembly/Bracket

    @Bardiya Sent you a PM
  8. OOCustoms

    Differences in dimensions between FJ45 2 door long bed pickup and FJ45 "Troopy" version?

    So that's a Troopy top and frame on there? Almost looks a little too big.
  9. OOCustoms

    Differences in dimensions between FJ45 2 door long bed pickup and FJ45 "Troopy" version?

    OK- I'm getting different answers from different sources, so I figured I'd ask the hive mind here. I have a 1968 FJ45 2 door long bed pickup (square bed with tie down hooks along the sides and tailgate). It has a cab hardtop over the front cab that's open behind the front seats- basically it...
  10. OOCustoms

    Busted ignition - ignition cylinder rod replacement

    Two things- did you install the Ebay part or the factory Toyota part? If you used the Toyota part you returned the bracket without the internal "key" part that needed replacing?
  11. OOCustoms

    Warped rotors or what?

    Yes, and a visual inspection/feel of the rotors shows nothing wrong
  12. OOCustoms

    Warped rotors or what?

    I have a 2003 with the EXACT same symptoms- when braking from speed to a full stop ( just normal steady pedal pressure to come to a stop, like at a stoplight). As the speed drops below 10 mph the vehicle begins this strange surging effect, with the surging getting more pronounced as the speed...
  13. OOCustoms

    Busted ignition - ignition cylinder rod replacement

    As far as I know, yes they are. It's a good idea to have the part on hand for if/when it happens.
  14. OOCustoms

    Solid source for a quality rebuilt 2F motor

    Just looking for any input on reliable vendors/sources for a new/ quality rebuilt 2F motor. Going in a 1973 FJ40.
  15. OOCustoms

    Searching for a set of headers...

    Just curious what is out there for headers now that DT is no longer available... I found these on Ebay- thoughts?
  16. OOCustoms

    Rear axle control arm brackets

    Hey does anyone have a source for the rear axle brackets for the control arms? I'd rather replace those then do a full axle swap. '03...Thanks for any info.
  17. OOCustoms

    1969 FJ45 LS conversion

    Hi all- I'm in the process of doing an LS 5.3 swap into a '69 FJ45... just wondering who has any input on exhaust options? I would like to use a Y-pipe, but open to others ideas. Any constructive input is welcome.
  18. OOCustoms

    Busted ignition - ignition cylinder rod replacement

    The bracket assembly is part # 45280-60610 from a Toyota dealership- I paid about $265. That's the smallest part group you can order separately. See my post above for details. Sounds like your Park interlock is malfunctioning. Try tapping the shifter while trying to remove the key.
  19. OOCustoms

    Busted ignition - ignition cylinder rod replacement

    DO NOT order just the cam from any aftermarket seller- they are not the improved design. Just order the correct part # 45280-60610 from a dealership.
  20. OOCustoms

    Rear Axle bracket for upper control arm + sway bar replacement source???

    Hmmm... for some reason when i search under 2003 LC that axle doesn't come up- only 2002 and earlier... I am not aware that anything changed from '02 to'03...thoughts?
Back
Top Bottom