Ed; just email the details to webmaster@clcc.org. It only takes me a few minutes to make a page.
The details I want are:
* Date
* location
* contact information (email and/or telephone)
Ed HAM's re-tune Firestik's for use on the 10 meter HF band (28 mhz - 29.7 mhz) which is just above the CB band. We are limited to 1500 watts on that band although few run that much power when mobile. So the published 700 watt limit is actually useful data to some of us.
Regards
-- Eugene
I have a used pencil I'll sell for $42 (free shipping to the lower 48). I will shaprpen the pencil prior to shipping for no additional charge (if the buyer requests it).
Price is firm. At this price the buyer must be dense.
The current listing for the 71 FJ-40 is 1971 Toyota Land Cruiser
Magnetic mounts / Firestick 5/8 wave antennas
The Firestick uses a standard 3/8" x 24 thread so if you want to use it with a magnetic mount you will need that type of magnetic mount.
Additionally the Firestick 5/8 wave CB antenna is a coil around a fiberglass core so it has more wind...
CB & HAM equipment
I wrote up a CB selection page for CLCC.ORG a long time ago: the URL is CLCC: CB Equipment and Selection
With CB you really do want an "RF Gain" control if you intend to use the radio for close-distance vehicle to vehicle communication; without the RF Gain control the...
Sam; Please say more about this. What you would propose is of some interest to me. The reasoning behind your proposal however is OF GREAT INTEREST to me. It should be of interest to everyone that is interested in the survival of CLCC.
Perhaps your alusion to the CLCC being a dead horse is...
Anyone willing to volunteer?
I too am not a good candidate for a CLCC officer. I am unable to attend CLCC meetings; at least until September (at the soonest).
It would be helpful for the past officers to share a litlle about what the various roles entail and/or what they needed to do...
vacuum & timing
The Mallory distributors alway seemed to have a sloppy gear interface which made for iffy advance and timing even when calibrated correctly at idle. Aviod the Mallory units in f/2F' engines.
I would do a thorough test for vacuum leaks and considder replacing any...
The last proposed CLCC ByLaws are posted here:
--> http://www.clcc.org/Bylaws/
Please Post comments the the CLCC email List (clcc@clio.lyris.net).
-- Eugene
Actually John I am one of less than a handful of persons to have been given a CLCC Lifetime membership. I no longer recall who the other Life members are. 8^P
In spite of this I have payed my annual dues every so often because I felt it was a good thing to do.
Regards
-- Eugene
If you have a copy of the CLCC bylaws please email to me your copy.
Send them to webmaster@clcc.org.
I want to Post them on CLCC.org.
Regards
-- Eugene
A foolish purchase for the CLCC.
Spending this much Club money on a tool which will be benificial to a small minority of CLCC members seems foolhardy to me.
I am not entirely adverse to CLCC owning such a tool. I am opposed to the increased liability which the Club assumes by owning...
The February meeting is when we elect officers.
I do not recall which officers need nominations.
I believe that Jim will continue in the role of Quartermaster.
Les has just taken over the Treasurer position.
We need to fill the following positions:
* TLCA delegate
* VP
*...
OEM vs OME 45LV Suspension options
The OME is the only aftermarket 45LV suspension I can recommend. It is a very nice suspension.
The question is will the existing suspension be OK.
I liked the suspension on this truck when I was driving it with the exception of the shocks which were...
50-series axles under a 45LV
What are the spacings between the spring pads on the front & rear axles of Marks 45LV and his FJ55?
I understand that Mark wants use the axles from his 55 on his 45LV project and both he & I are unsure what what these measurments are.
Regards
-- Eugene