I have to change the rear axle bearings and seals on my 1997 4runner. I am curious if anybody has and is willing to rent or lend me a couple of tools. otherwise I'll have to spring for the tools myself.
tools looking for:
20 ton shop press
Rear Axle Bearing & Tone Ring tool...
My wife booked us a cabin in strawberry for New Years weekend. There should be plenty of snow for us to play in… in fact there might be too much snow for some trail riding but I’d like to try.
I’ve done some searching through old posts here and have some ideas, but would love some input from...
My wife booked us a cabin in strawberry for New Years weekend. There should be plenty of snow for us to play in… in fact there might be too much snow for some trail riding but I’d like to try.
I’ve done some searching through old posts here and have some ideas, but would love some input from...
I’ll answer my own question for future guys... I did drive up to Payson from Scottsdale and it did a lot better have the head was serviced by the machine shop. I replaced the gear and the noise is gone. I probably drove more than 500 miles before I could replace the chipped gear. So In my...
I spilt some out of mine maybe 2-3 ounces. I added some back into the torque converter. However, I was told transmission fluid is pumped into the torque converter from the transmission so what I lost would not have been a problem if I didn’t replace it directly into the torque converter.
this is my issue. i put the motor back in after doing the cylinder head and it was running incredibly quiet. then i realized i hadn't put power steering fluid in, so it was running dry. as soon as i put the fluid in the load ticking started. there was a small chip in the power steering...
Does that noise sound like a valve issue to you? Ive got a similar noise. I am going to do a leak down test when I have a chance. Cylinder 4 is missing pretty bad on mine.
I was jiggling my wire harness to see if it was getting melted on the egr pipe and causing my misfire problem.... I gently touched the heater hose and it broke off the valve nipple! Glad I was at home when it happened!
It wasn’t the most precise process I didn’t measure what came out. I drained as much as I could after putting it in the oven and outside all day in 100+ weather. Eye balled 50 mil of the 20,000 cst. When I compared how 50 mil looked versus how it looked from the factory, I filled it more than...
Ordered a blue clutch from rock auto, drained and filled with 20,000. I did not adjust the temperature on the blue clutch. Removed the black clutch with 260k miles on it that still had good resistance to manual spinning. Noticed a big strain on the engine and no difference in my ac temps at...
This was over the course of a couple weekends, but i added sound deadening and sound insulation to the front and rear doors and the rear panels. it is noticeable quieter at low and high speeds. i find myself driving much faster on the highway because the road noise sounds like i am driving...
I was able to find Probrecito, I never realized that was an entrance, but it looks like it would take a lot longer to get to the coves. it was open today. I took some pics of the maps at the entrance. I wish I saw them on my way in versus my way out, I had no idea where I was going.