Is there a good OEM replacement for the cotter pin clamp (8712428030), I just realized I ordered a bunch of these (working off a parts list) for my heater hose update an they look like a PIA and apparently need an SST.
thanks,
Scott
I am rehabbing some of my radiator hoses and when I pulled the hose off the thermostat housing there was a bunch of "sealant" and after sealant removal exposed the pock marked surface you can see in the foto. I am not really a fan of sealant here (it was working albeit weeping a bit during the...
Well most of my factory roof rack nutserts are relatively healthy except one.
The area around the nut is a bit swollen and the nutsert is spinning.
Anyone have any suggestions how to keep the nutsert from spinning? I have never dealt with these before. Can I tighten it up with a tool somehow...
I would like to remove my roof rack and go back to the factory roof rails on my LX450!
Anyone in Central Texas (Austin) have a lead on a nice set?
There must be a boneyard full of these somewhere.
Scott
Granted, I purchased these seat covers slightly used so they have been installed and removed a couple of times, when I received them the edges were still relatively clean cut.
The cut outs for the seat controls and the headrest are simply "thread cut" the edges are not treated at all...
Hi folks,
Do the pictures look like a power steering leak? (I really dont notice a lot of fluid loss and seems to work fine)
If so, would this mean pump replacement? If so, any recommendations where to have it rebuilt?
thanks,
Scott
I guess the bolt is missing from this bracket, looks like the PO used a zip tie to hold it and some cables on. Can someone tell me what it is and what I am missing.
thanks,
Scott
I am trying to replace my antenna which is bent, the cable comes most of the way out when I push the up button but then it gets hung up.
I have attempted tugging on it but really do not want to break it off (or anything else) in the reel if I can avoid it.
Has anyone come across this? Any tips...
Hi folks,
looking for some tires (285/75-16) recommendations for my '97 2" OME lift with ARB front bumper.
I live in TX and do not "wheel", some gravel and forest roads in Colorado - those washboard roads about killed me this summer.
I currently have nitto terra grapplers (load range E) from PO...
Can somebody identify this harness (see red arrow) under the fuel filter ('97 LX450), there is a plastic clip that holds the harness and attaches to a block mounted bracket and I would like to order a new plastic clip, mine fell apart while doing a fuel filter replacement.
thanks,
Scott
I have a replacement cover for my warn winch but do not understand how to wire it into the new cover.
The wires come from behind the cover up into the round connector and then it appears something ( a sleeve?) captures them from the front.
Can anyone shed light on this?
thanks,
Scott
Does anyone have the part numbers for the O-rings that go onto the top of the dipsticks (tranny and engine), I keep getting the part number for the tubes from my lexus dealer and can't seem to find the #s for the dipsticks themselves.
thanks,
Scott
Newbie here looking for an opinon on my birfields
'97 LX450 relatively new to me, currently with 115K miles. Last recorded service of the birrfields was by dealership in 2004 at 50K miles.
I don't actually see anything dripping, would you all consider these leaking badly? If so, how long can I...
Hi folks, new to me LX450 (115K miles) and would like to get your opinion on something. I am planning a trip to Colorado in the next couple of weeks, probably 3000 miles round trip. I know from PPI I should replace the radiator (and belts) because of discoloration but also have a minor oil pump...