Search results for query: *

Forum search Google search

  1. pumbaatx

    For Sale San Antonio, TX: H42 4 Speed Transmission from 1987 FJ60

    Bump...still available
  2. pumbaatx

    For Sale San Antonio, TX: H42 4 Speed Transmission from 1987 FJ60

    @72bluefj55 I cleared a spot in my inbox if you want to try to PM again. The transmission is still available
  3. pumbaatx

    For Sale  San Antonio, TX: H42 4 Speed Transmission from 1987 FJ60

    This transmission has a leak in the front main seal. I had been trying to track down an oil leak for months from my engine and it turns out it was the transmission. Anyway, I ended up swapping to the H55f 5 speed and have this tranny for someone who wants to rehab it. The previous owner gave me...
  4. pumbaatx

    3/18 Special Request

    Awesome, thank you Josh!
  5. pumbaatx

    3/18 Special Request

    Hi everyone, My fiance and I relocated from Austin to San Antonio back in October, and I am looking forward to joining some cruiser meets in the city soon. She and I will be getting married next Saturday 3/18 at the McNay. We had hoped to use my white 1987 FJ60 as our send off vehicle, but that...
  6. pumbaatx

    Wanted Driver Quality 60, ideally with 5speed

    What is your budget? My transmission just went out and I am in the process of acquiring parts for a 5 speed swap and T-case rebuild. I figured I wouldn’t get the right money without doing the transmission before listing.
  7. pumbaatx

    THE best way to change oil pan gasket!

    For those of you FJ60 owners, like myself, that this is not abundantly clear, you need to take off the clutch inspection cover to install your oil pan. I did not see the procedure in the 2F FSM, so I went to the 3F manual, which of course does not mention this step. I can’t believe this was not...
  8. pumbaatx

    Loss of power/stalling/bucking under load

    My truck has started to behave strangely on long trips. If I drive for less than 20-30 minutes, I never seem to have a problem. After the engine has been running for a while (usually at highway speeds), it seems to have problems when I try to increase the load. Usually this presents itself as...
  9. pumbaatx

    Low voltage until revved

    I’m still likely going to pick one of yours up as backup after I get this resolved, Matt.
  10. pumbaatx

    Low voltage until revved

    Ok the new one came in the mail today. Anything I should do to test the system to make sure I don’t pop the new one by installing it? Trying to decipher anything else related with the wiring diagram. There’s a ground on one pin of the relay, the dash light, the alternator, the ignition, and...
  11. pumbaatx

    Wanted 84' fj60, brown interrior. I am look for both rear wheel well covers

    Here is what I have, let me know if they’re good enough or not for condition.
  12. pumbaatx

    Low voltage until revved

    The 80 series relays work for the 60?
  13. pumbaatx

    Low voltage until revved

    Well, what is a charge lamp relay supposed to look like? I can’t see anywhere where I visibly think I see a short, I’m also not getting continuity between posts 1 & 2 or 1 & 4 like the FSM states I should. Are these rebuildable with solder or am I SOL?
  14. pumbaatx

    Low voltage until revved

    Also, the large circuit breaker labeled POWER is also missing. Wtf? Seems like I probably need that, no? It’s been running for 3 years without it unless it got swiped.
  15. pumbaatx

    Low voltage until revved

    Alright, the green plug on the back of the alternator has no power and the engine fuse in the cabin is blown. Any reason to not just put another fuse in and see if it holds? What causes that one to blow?How does adding load cause the alternator to be able to charge?
  16. pumbaatx

    Low voltage until revved

    Alright, here is what I found in the FSM. Seems that it could be a few things, so I’ll check these soon.
  17. pumbaatx

    Low voltage until revved

    I am dealing with an issue where the voltage after starting is low. I can drive around normally and the ammeter remains low, under the halfway mark on the gauge (guessing around 9-11V). Once I rev the engine above 3k RPM, the voltage jumps back up to normal levels (guessing 14.4V or so). If I...
  18. pumbaatx

    For Sale Austin, TX: 1987 FJ60 FJ62 Brown Pinstripe Rear Bench Seat For Restoration

    It can if that's what you need. I have both the frame itself and the rails.
  19. pumbaatx

    For Sale Austin, TX: 1987 FJ60 FJ62 Brown Pinstripe Rear Bench Seat For Restoration

    Update on remaining available parts: Front seat upper foam Front seat lower foam - SOLD Front passenger seat frame with mounting rails and brown recline handle Rear bench seat upper and lower fabric - SOLD Rear bench seat upper and lower foam Rear bench seat frame with brown trim channels
  20. pumbaatx

    Charcoal Canister Rebuild

    Never mind, little taps with a rubber hammer around the top got it to release.
Back
Top Bottom