Search results for query: *

Forum search Google search

  1. ClassyJalopy

    Katit's LX470 2000 - take #2

    I think that is correct. Fuel pressure Fuel pressure at no vacuum 265 - 304 kPa (2.7 - 3.1 kgf/cm2, 38 - 44 psi) Fuel pump Resistance at 20°C (68°F) 0.2 - 3.0 W Injector Resistance at 20°C (68°F)
  2. ClassyJalopy

    Builds Patch's Build Thread

    Without any data to backup, my gut feeling is reduced up travel will cause the truck to lean more on off camber obstacles. Perhaps a body-lift would provide the additional clearance needed for larger tires without sacrificing the up travel?
  3. ClassyJalopy

    The MUD 100 series Photos thread

    Right headlight out?
  4. ClassyJalopy

    Builds Patch's Build Thread

    I see you are planning to increase the down travel but decrease the up travel. Any concerns with the reduced up travel?
  5. ClassyJalopy

    Katit's LX470 2000 - take #2

    Are you sure it is not the central brake light seal that's leaking?
  6. ClassyJalopy

    replacing AHC globes/accumulators

    Keep at it. It will come out eventually. Mine gave me a bloody fight too! https://forum.ih8mud.com/threads/the-story-of-blue.1244337/post-15084454
  7. ClassyJalopy

    More fuel range for the late 100... Or sell it and start over?

    gas tank is in the frront of rear axle and the spare tire mounts behind the rear axle. Never the twain shall meet
  8. ClassyJalopy

    Builds Project Code Name "ASAP Flaps"

    I feel like I saw not too long ago he was planning to expand his offerings to 200 series too! But If Rami is no longer willing to produce these perhaps we can coax @cruiserpatch or @suprarx7nut to buy his design and produce them??
  9. ClassyJalopy

    Builds Gerry's Build thread: "If it happens again I'm buying an Abrams"

    Why not pull front and rear DS (one by one of course :rolleyes: ) to rule out the drive shafts? That's how I found my vibration issue last time.
  10. ClassyJalopy

    Builds Project Code Name "ASAP Flaps"

    I left one of my fronts at Pearl Pass off Aspen CO. Have been meaning to reach out to @Ramathorn15 to see if replacements can be sourced.
  11. ClassyJalopy

    Katit's LX470 2000 - take #2

    If your fuse box is alreafy replaced then more than likely you don't have an EFI issue. I had a similar experience as @Trapper50cal where I ended up replacing the fuel pump. My old pump was only 2 years old with abt 20k miles when it failed. OEM too! More here: Builds - The Story of Blue -...
  12. ClassyJalopy

    Katit's LX470 2000 - take #2

    a. and b. If you turn your key to second position (Just before cranking) and the security key light goes off on the dash then your EFI is fine. More details here: EFI Relay Bypass Kit (Immobilizer Fix) for UZJ100/LX470 -...
  13. ClassyJalopy

    Katit's LX470 2000 - take #2

    I have replaced valve cover gasket on a 4.7 before. Not a hard job actually. If you have oil in spark plug tube then it looks like you will need to replace the VC gasket as well as the round tube seals. If the only leak you see is oil dripping out from the side fo the VC, then I recommend...
  14. ClassyJalopy

    FJ62 to 100 Series - Land Cruiser Journey Continues

    I have a much humbler setup with 2 Lead Acid betteries under the hood. I ran a 650 watt microwave on Renogy 2000W converter but had to keep the truck running to save the battery from being drained. You should have no issue running a microwave on this setup .
  15. ClassyJalopy

    FJ62 to 100 Series - Land Cruiser Journey Continues

    Thats a lot of battery! Are you planning to run a microwave?
  16. ClassyJalopy

    Product Request: Blue Sea switch mount near battery

    Been a while so I don't recall exactly - but I do remember that you can reuse all the existing hardware for mounting. I think you can still have the ground in the same place even if one 'leg' of the mount has to go underneath it
  17. ClassyJalopy

    Product Request: Blue Sea switch mount near battery

    This one: 100 Series Land Cruiser and LX470 Accessory Tray - https://owlexpedition.com/collections/100-series-land-cruiser-lx470/products/100-series-land-cruiser-and-lx470-accesory-tray
  18. ClassyJalopy

    2" body lift on low km unmolested JDM 100

    Great work so far! Having those fab skills is very impressive. Also, I want a 'third eye' for my LHD truck but I don't think anyone makes it
  19. ClassyJalopy

    FJ62 to 100 Series - Land Cruiser Journey Continues

    This is coming along nicely! I wasn't a fan of the tailgate storage even though it added a ton of space. It just made the tailgate too heavy to safely operate for my wife and kids.
  20. ClassyJalopy

    For Sale Las Vegas: 2 sets of 5x150 TRD Tundra Wheels - Great condition

    I want this set! How are ppl shipping wheels?
Back
Top Bottom