Search results for query: *

  • Users: 4lo co
  • Content: Threads
  • Order by date

Forum search Google search

  1. 4

    A/C Compressor not cycling

    1995 FZJ80 Recently replaced most of the A/C system. Installed new compressor, condenser, dryer, expansion valve, pressure switch. Using vacuum pump, removed moisture and added freon with manifold gauges. Low side pressure was around 25 and high side pressure 275ish (maybe a little higher) with...
  2. 4

    2005 LX470 VGRS ECU

    My LX470 has the VGRS, VSC OFF, and VSC TRAC lights on. They are steady and remain on all the time while driving. Took it to Toyota to get diagnosed and the codes pulled were ABS: C1289, C1291, C1340 VGRS: C1554, C1568 AHC: 1777. I was told these are all related to the VGRS going bad except for...
  3. 4

    Fuel Gauge/Sender Issue

    I have a 92' 3FE LC. Recently I replaced my fuel sender with another used unit that was known to be in good working order because my gauge needle was jumping/dancing and not marking correctly. The needle shows a fairly accurate depiction when I accelerate and then I let go of gas pedal, the...
  4. 4

    Recharging AC Help!

    My compressor recently seized up on me so I replaced compressor, condenser, drier, expansion valve, and all o-rings. I rented manifold set and vacuum pump and its holding a vacuum. When attempting to refill the low side pressure shoots up to 100-110 with the vehicle running. I couldn't get the...
  5. 4

    1974 FJ40 drivers side birfield axle won't go in all the way

    I've looked up all instructions on how to do this. I've gotten the passenger side to go in but can't get the drivers long side to go in all the way. I carefully push down against the inner axle seal to get leverage. I also wiggle the driveshaft simultaneously and have had no luck. I keep getting...
Back
Top Bottom