Looking for replacement connectors for knock sensors on a 93 1fz-fe. Can't figure out a part number through Toyota. Lots of options on ebay but can't confirm fitment. Also, do I need to go genuine toyota on the knock sensor itself or will rock auto replacements work. I.e ATK, WVE, standard auto...
Removing egr from 1fz-fe. Engine not in vehicle. Vehicle for offroad use only in Wyoming. Wanting to remove hoses under intake and block of egr pipes while it's apart. Saw an old thread a couple years ago for a full removal with good pictures and instructions but cant for the life of me find...
swapped a 94 1fz-fe into my 93. Both vehicles ran and drove before engines were pulled. Have gone through the emergency troubleshooting thread. Replaced fusible links, relays and fuses. Cleaned and double checked all grounds verifying less than 1 ohm. Verified battery 12.46 volts and same power...
Doing an Engine and drive train swap. Donor vehicle is 94 Non ABS with HF2A. Vehicle its going into is a 93 with ABS that has the HF2AV case. Ive done the research and understand the differences between the two however I dont quite grasp how those differences translate performance or drive...
Cant find much info on this topic. I'm swapping an engine I got from a wrecked 94 into my 93. I live in north west Wyoming where a/c is not needed. Is deleting the ac system as simple as just removing the compressor and lines or is it more complicated than that and not worth the trouble?
Can anyone help me out with a part number for replacement bushings for the front sway bar? Not the bushings to attach to frame but the bushings for the ends of the sway bar where it attaches to front axle right behind shocks. Can't find any oem or moog or energy.
So i purchased a 93 cruiser with 300k miles on it for $500. My plan was to do a tune up and use it for an off road play rig. Right off the bat I trashed the VAF by removing the 2 screws thinking I was going to pull it out and spray it with MAF cleaner. WRONG. Well I sent that off to Cardone to...
just purchased a land cruiser for my girlfriend. 93 beater for $500 with the plan of restoring it for her. Right off the bat I busted the maf sensor. Removed the 2 screws and figured it would pull out and I could spray it off. Well....not. So what are my options for replacement without paying...