Search results for query: *

Forum search Google search

  1. JerseyCruiser

    Radiator rotting away.

    I bought my 1993 Land Cruiser in 2006 with a radiator core that was disintegrating above the bottom tank. The radiator was aftermarket so I replaced it with a TRAD three row copper core from Cruiser Dan when my head gasket went a year later. About four years ago the radiator started leaking...
  2. JerseyCruiser

    For Sale  1993-1997 Hazard Switch

    Hazard four-way indicator switch used (84332-42010) $30.00 free shipping CONUS Send me PM
  3. JerseyCruiser

    For Sale  1995-1997 CDL Switch

    CDL switch (84725-60040) used for a 1995-97 Land Cruiser. Send me a PM $50.00 free shipping CONUS George
  4. JerseyCruiser

    Drivetrain issues

    I was wondering what could be the cause of a slight bucking/ jerking in my drivetrain while making slight right turns (¼ turn on wheel) on the highway under throttle? This doesn’t happen at low speeds or if the wheel is turned hard over. Thanks George
  5. JerseyCruiser

    Low oil pressure after truck has been sitting for 6 months

    I have a 1993 cruiser that's been sitting outside since December, finally changed out a leaking power steering hose and got it fired up again and now I notice at idle and up to 25 mph the oil pressure is on the lowest line then it will move to ½ way then go back down as it always showed about ¾...
  6. JerseyCruiser

    Where is the best place to cut open stock muffler to clean out cat debris?

    My cats had a meltdown and now all of the pieces of their core reside in the inside the muffler and possibly in the resonator. Where is the best place to cut it open to clean out the junk and have it welded back up? Can the resonator be opened and cleaned out to, if so where do I cut? The price...
  7. JerseyCruiser

    Melted cats! Need some options.

    Just discovered that my cats are junk as a result of running the truck with a bad #6 injector that caused them to glow cherry red. Half of one cat is melted and the core of the other one is completely gone and is nestled deep inside the muffler and possible the resonator in the tailpipe! I need...
  8. JerseyCruiser

    Melted EGR Vacuum Modulator

    After smelling some burning plastic I looked under the hood to find the EGR modulator in an extremely melted condition and it even melted some of the hood insulation. All the hoses are connected none were loose. My question is can blocked, or melted cats be the cause of this? I've been lightly...
  9. JerseyCruiser

    Replacing temp. gauge sender sensor, do I need sealant?

    I'm going to replace the temp. sender in the head when I have the engine drained for a coolant flush. Do I need any type of sealant on the threads when I reinstall it, and if so what kind? Thanks George
  10. JerseyCruiser

    Can I test fuel injector resistance at ECM

    I've been trying to find the cause of my misfire and severe lean condition and want to check my injectors, is ther a way to check their resistance at the ECM wiring without having to remove the TB? I also want to check the injector wiring so this is another reason from testing at the ECM. I...
  11. JerseyCruiser

    Can 02 sensors be bad without throwing a CLE code?

    I have a severe lean running engine problem. The truck will idle OK but it is a little rough, when I give it gas it will shutter and go only about 5 MPH with the skinny pedal floored. After a few minutes the cats and Y pipe are a nice cherry red i'm sure I probably toasted them dam shame because...
  12. JerseyCruiser

    New Remanufactured VAF Air Flow for 1991-1992 3FE FJ80

    Mass Air Flow Sensor VAF *NEW* For 1988-1992 3FE FJ62 FJ80 SOLD For sale is a Mass air flow sensor VAF for a 1988-1992 3FE FJ62 FJ80 it is a new re-manufactured part sold by Python Injection it replaces OEM part: 22250-61010...
  13. JerseyCruiser

    Fuel Injector Resistance

    Does anyone know how to check all of the injectors resistance at the ECM instead of accessing each injector? I see terminals #10-#60 on the ECM in the FSM but I don't know where to meter the other side of the injector. Its a PITA to access all the injectors without removing things and I want to...
  14. JerseyCruiser

    What type of grease gun is everyone using?

    I'm looking for a reliable one hand operated grease gun, and was wondering what if any fit that category? I've tried the pneumatic guns from Craftsman and Harbor Freight continuous and single pump flow and they are all garbage, they all loose their prime after a few trigger pulls. How are the...
  15. JerseyCruiser

    Anyone running thicker tubed drive shaft?

    I wrecked my drive shaft and had it re-tubed with 1/4" DOM at my friends shop, it then developed the typical u-joint buzzing on deceleration, I had the u-joints replaced at a drive shaft shop with Spicers and I still have the same noise. The guy at the shop said he will not be able to eliminate...
  16. JerseyCruiser

    OEM Wiper Refills

    I went to my dealer and was told that the wiper refills can only be ordered in quantity of ten, is this true? They said its just like any part priced under a dollar that are now shipped in quantity of ten. Wondering where everyone is getting there refills from.
  17. JerseyCruiser

    Cold acceleration bog and sometimes rough idle

    Sometimes when my truck is cold winter or summer under hard acceleration like pulling away quickly from the curb it will loose power (bog down) for about 1/2 a second and then recover and be fine. It won't do it at any other time just that first hard pedal push and might be good for days or...
  18. JerseyCruiser

    Factory Paint

    Is this a factory paint job?
  19. JerseyCruiser

    Wanted  1993-94 Rear Driver Side Fender Flare

    I'm looking for a driver side rear quarter panel fender flare from a 1993-94 with no cracks or missing mounting points. Thanks George FOUND ONE, THANX
  20. JerseyCruiser

    Transfer Case Vibrations

    After my last wheeling trip this summer I noticed the rear output seal was leaking on the TC after replacing it and the rear output bearing the truck has a terrible vibration over 60 MPH on deceleration. Then I took out the rear DS, locked the CDL and it drives perfectly. The DS is not the...
Back
Top Bottom