Been having a charging problem recently. Symptoms began with low charge at idle. I was getting between 11.9 and 12.5 volts off the alternator. Replaced alternator with a reman Toyota, cleaned all grounds and all connections to the alternator and battery. Also did fusible links as mine were a...
Is there supposed to be a ground cable from the alternator to frame? Or is it grounded from the alternator body by the mounting bracket? I don’t seem to have a cable and would like to add one if it belongs there. No issues, just want to make it right.
thanks
So I’ve got a brand new shake after installing landtank 2.5 caster plates. Only happens between 10-20 mph. 1995 with OME 851 with 30mm spacer up front and OME 866 rear. Front driveshaft is brand new. Rear driveshaft has new OEM u joints. This had the washer mod done before I installed the...
Quick question. I’m about to install caster plates. Is it necessary to adjust toe after? I’ll probably check it anyway but was just curious if it’s a must.
thanks
So I needed my u joints replaced last minute before a long trip and didn’t have the time to do it myself. Took it to the local dealer and this is what I got back. I dunno if it’s right to put up who it is so for now I won’t.
Brought it back and talked with the service manager. They are comping...
Looking for recommendations for a place to balance my driveshafts and replace the u joints. I’ve already contacted Overland Driveshaft in Montville CT and they won’t use customer supplied parts. They use Spicer or Neapco and I’d prefer OEM. Any places you guys can recommend?
Thanks!
So I’ve got a constant hissing noise while the rig is running and it continues a second or two after the rig is shut off. It sounds as though it’s coming from under/inside the intake manifold. It could have been there since I’ve had it for all I know. You gotta have your head pretty close to the...
So after two brand new OEM masters being bad out of the box I’m going to have a go at rebuilding my original. Can someone confirm part number 04493-28090 is the correct one?
Thanks
I’ve cross posted this to the 80 forum. Can anyone recommend a good shop to replace my old dual cats with a single one and O2 sensors? I’d rather not deal with it as my welding skills have a lot to be desired. I’m in CT but willing to travel for a good place.
Thanks
Can anyone recommend a good exhaust shop in Connecticut or southern Mass? Looking to have the dual cats replaced with a single one and new O2 sensors.
Edit: cross posted to Yankee Toys clubhouse
95 80 series. Got a question on brake pedal sinking to floor. I have replaced master cylinder and all soft brake lines with OEM parts. New pads and rotors. Also deleted ABS and LSPV. Bench bled the master and bled the brakes using the two person method as well as using a power bleeder set to 10...
Does anyone have a brake booster SST that could take some measurements of it for me? I’d like to try and 3D print one since the OEM ones are $$$$.
Thanks!