better than expected . It has some wear and tear but not enough to make me want to redo it. Over all happy with the end results. I do not treat it softly, pressure wash at car wash, scrub brush etc. Its holding up.
I have found a good cleaning of the throttle body, MAF and clean air filter help with the RPM going up ever so slightly and the drone disappears. I am currently having the drone noise but have not had time to go thru and clean everything up. YMMV
I experience something similar.
Rear A/C runs , sends out cold air from the rear UPPER vents.
However, it begins to cycle on and off erratically.
Over the course of a long drive it will switch off the upper air and then goes to heat from the lower vents on the backside of the center console...
Got this from Dissent 8 months ago but just haven't had time to get it finished up. Picked up from the powercoater today... Gloss Grey for the main three pieces of the bumper and satin black on the stinger and connecting plates.
Hoping to get it mounted this week.
My understanding is that there are two options. For third row seats... Pre cut but smaller overall foot print, i.e. Coverage
The other is full rear coverage but you need to modify the cutouts to work with 3rd row seats
Check out John Watson @johnprolly on Instagram
He has, if I remember correctly, a Costa Fabrication rear bumper with a 2" receiver on the swing out. He uses a One Up bike rack.
This also allows for increased clearance to the rack
Check out this thread. May shed some light. I have read about flappers not working properly, regrease, adjust etc helped distribute air properly.
https://forum.ih8mud.com/threads/cold-air-on-passenger-side-floor-has-anyone-figured-it-out.690833/
A few pictures from the first half of the drive.
Thanks for the open invite @geanes and it was a pleasure meeting everyone. Everyone had some killer rigs, although a little partial to Mauricios exploring 80 series
Gamaviti Mounts and Aluminum 80/20 struts is what I used for my Yakima basket. I like it because it kept it with a lower profile. I originally just laid the basket on the stock roof rack/rails and it sat super high ... Great find though!
Speaker swap
Not an audiophile so just looking for an upgrade with no major modifications
Found 6.5" kicker speakers that dropped right into the nakamichi cradle. Screwed them in and reinstalled the door panels
Finally got around to running wires and getting my 6 switch bank operational
Cut out the Homelink BS (99 Lx470) , found a 6 gang switch with a black aluminum housing.
Rewired the pre-wired switches because there is not much room in that space above
Now I need to finish wiring up the rest of...