Have a rolled LHD FJ80 that has a HDJ81 drivetrain swapped in. The vehicle harness was modified from the RHD HDJ81 to fit the LHD FJ80 and maintain factory operation of all components. The engine harness has been lengthened to accommodate the firewall hole being on the opposite side. I am a...
I had another thread going as a a feeler to get an idea how I was going to attack this. I've since decided to go in a direction that I guess hasn't been done before. Basically, I rolled my loaded HDJ81 and I'm going to attempt to rebuild it using a FJ80 body and frame.
I want to make it clear...
Parting out a running FJ80. 160,000 miles. No body parts at this time- the body and frame are donors for my rolled HDJ81.
So basically, the drivetrain and ECU is up for grabs at this time. I will get rid of the odds and end when I am done. Everything worked when pulled.
Notes: The vehicle had...
So back in May of this year, I totalled 3 sleds, my tandem trailer, and my trusty HDJ81 on the way up the mountain behind my house. Truck had only basic coverage as I only drove a couple times a month, mostly on FSRs. No insurance.
So I bought an FJ80, pulled the gear out of my HDJ81, and the...
My parking brake is slack lately, to the point where the bellcrank levers go past their guide slots on the backing plates and get stuck, requiring you go under the truck to release the brake.
I've looked at the backing plate- there doesn't seem to be anywhere to stick the old screwdriver in...
A recent oil change revealed I chipped a small tooth fragment off my front diff, probably while giving a huge Dodge Cummins a tug in reverse. I know this 8" reverse cut gearset is weaker going backwards, but it was the only way to free him, no space to turn around, my winch just pulled me closer...
this came off my HDJ 81. its the factory 8000lb Aisin winch, cannot feed out, the brake jams in reverse due to a twisted helix shaft. could have been due to the winch mounting plate flexing, this design has no tolerance for the winch housing flexing because then the internal thrust clearances...
SOLD!!!
Parting my rolled '85 4Runner dd/rockcrawler with 3B/H42/toybox doubler. Will also consider selling the whole truck, cab is donezo, but it still runs/drives great.
-'85 3B 3.4L diesel, 12V, about 245km on this motor, runs excellent, can get numbers for it
-H42 with Marlin toybox...
Is it possible to put an R151f behind a 3B? which foreign or domestic croozers had this set up, and what are the input and output spline counts, and if i'm correct, this tranny has a male input and female output?
hey cruiserheads
some of you may have seen my 3B in an '85 4Runner thread a while back. https://forum.ih8mud.com/showthread.php?t=130965
anyway, i've been toasting stock trannies, the W56 5spd that bolted behind the 22re (2.4 EFI) from '85 to '95. The first one made noise as soon as i drove...
this is for my 3b in my 4runner
wheeling season is fast approaching, just trying to take care of some loose ends... my donor engine had the 1" crackcase case vent tube coming out of the rocker cover, where should i run this thing? i was thinking diesel exhaust would have too much heat and...
no pics of the swap yet, camera broke, but here is a pic from a couple months ago:
questions first:
1) how do i get my efi tachometer (sending unit was the distributor) to work with the 3B's flywheel sender?
2) i currently am running the glow plugs off a 25 amp switch w/o any relay. i...