CAD isn't too bad to figure out. It's mostly just drawing lines and shapes, and setting dimensions. I use Autodesk Inventor for most things honestly (even though I have much more advanced CAD programs at my disposal). Once you have a flat 3D part, you can export the face and have a 3rd party...
Any updates? Planning on tackling ABS door cards soon.
What are the chances of you would share your CAD files so this engineering student can make some magic happen?
:cheers:
Unsure if you figured your issue out, but my code 12 ended up being an issue with the hall effect sensor internal to the distributor. There's no electrical test for this outlined in the FSM although if you're handy with signal reading I suppose you could. But it basically comes down to the air...
I've been experiencing code 12 as well, though I don't have a dual battery set up. All the distributor wiring to the ECM ohms out fine, I have also tested the distributor itself and swapped ECMs. This points me to the distributor being the problem child, however being that the distributor tests...
2012 Range Rover Sport HSE (L320) seats.
Tons of adjustability, and heated. Both seats have lumbar and driver seat has bolster as well.
I am 6 ft tall for reference, pant length 32.
I'm absolutely in love with these seats. I do have to have them at the minimum height setting. They'd be great...
Installed power seats from a 2012 Range Rover Sport and gave my interior a full detail (after 7 years of ownership🤣).
This seat swap hasn't been done yet and there were complexities to bypass the CAN Bus, but I'll be making a full write up with all the necessary info to make it straightforward...
Every year for Halloween, me and a handful of Toyota friends go offroading/camping for the weekend. This year was our first time going to General Sam's Offroad Park which is near Houston, TX. Super muddy, given that it had rained a ton leading up to the trip. I believe we were the only Toyotas...
Hey all, got an offroad trip coming up for Halloween, and my AFM just took a dump on me. Looking to get a replacement for my 1993 FZJ80 ASAP!
Located in Austin, TX.
Cheers
Put a good-used one on🤷🏻🤷🏻 a lot of time spent for a such a trivial thing!
There are ways to convert the OBD1 trucks to a MAF sensor, but for the time and money spent you can run a standalone ECU and do way more cooler things.