2002 4Runner 5VZ-FE
Just did timing belt and replaced knock sensors and when I put it back together and fired it up it has a constant miss on cylinder 5. Ruled out the routine stuff and did a compression test to find it has 100 psi. Did some research and found that if you pour some oil in the...
I’m having a fuel leak at startup from this area by the carb. I’m kind of a noob at this stuff so I can’t really explain where it’s coming out so here’s a picture. Had the carb rebuilt by a company called national carburetor here locally. Is this something they would’ve caused in the rebuild...
Cruiser overheating after idling for 5-10 minutes. Creeps up gradually and eventually approaches the red. I verified that it's not just the unreliable gauge with an infrared gun so that can be ruled out. I just had a lot of items replaced including the carb rebuild; I need to have the carb tuned...
Losing my mind a little here and need another set of eyes on this. So I’m replacing the head gasket on the 60 and accidentally discarded the old head gasket. Trying to get the OEM gasket from Toyota but they’re telling me my VIN doesn’t pull up to verify which gasket I need. 1985 had 2 options...
Having an issue with the KDSS system and going to delete it and replace with aftermarket rear sway bar and oem front sway bar. My question is how do I get the KDSS light off after removing everything? I've searched and can't really find anything.
I have a 1991 LJ70 with the 2L-T Diesel in it. I purchased it as non-running condition as it had been sitting for a good while. I dropped the fuel tank, cleaned it and put fresh diesel with some injector cleaner in it. I've also changed the fuel filter and air filter as they both were overdue to...
Just acquired 2 new Land Cruisers that need some work. One is an 87' BJ71 (trying to figure out which motor is in this one as there's not a lot of markings) and the other is an LJ70 with the 2L-T (I know there's 2 versions of this and I'm assuming this is the earlier model). I've bought them in...
Cylinder 1 lifter is believed to be collapsed at the bottom where it meets the cam lobe. Looking for input on how to remove as it seems to be stuck. Will move freely until a certain point (about 3/4" exposed) and then will not move further. There's room to get channel locks etc. on it but no...
Looking for FJ60 door jam molding in gray for the drivers rear door opening. If anyone has a lead on one of these that would be awesome. Pic attached for reference (Pic is from right door opening)
Thanks in advance!
Hey guys,
Searched the threads and couldn’t find anything on this issue. I have a Bendpack 10,000 2 post hydraulic lift and want to do the brakes on my 83’ but I can’t find anything in the manual for 60/62 series lift points. I wanted to see if anybody has input on the safest lift points...