I've got an Offy 4 barrel intake just sitting, and I've got 3 4 barrel carbs to choose from. So tempting to hook it up but like you I've got a Weber on the factory intake that is running really well. My engine has the Man a Fre dizzy and cam, with a header so it's a bit hopped up. Might...
After redoing some of the grounds ( there were none) the ticking noise has subsided a bit. Still goes away when I pull the #6 spark plug wire. Now mostly hear the ticking on startup idle, but quieter on warm up.
Also purchased a stethoscope. Was able to hear the ticking noise the further back I...
Just got the FJ back from the shop. It’s just going to have a little tick. Maybe it’s the fuel pump, maybe it’s the Man a fre distributor. Who knows, she runs great.
Go up to Bonham and look up Pete Phillips with United Motors. I posted his info in the FJ Shops list. My dad and I have used his shop for other cars and he’s been honest to work with.
https://m.facebook.com/100057382812898/
finding shops is hard, you have to find a dozen shops by googling...
Same issue. When In 4wd, and I let off the gas, I can hear the tops of gear teeth chattering. Transfer case was just swapped with a rebuilt one, since the old transfer case was cracked. I’ll take a look into the front diff sometime soon.
was looking to install a Donaldson filter to my Weber 38. There’s plenty of room inside the engine compartment on the drivers side. Has anyone tried a similar setup?
Donaldson B055006
2.5” Air Inlet
https://shop.donaldson.com/store/en-us/product/B055006/31220?_requestid=5580679
Weber 38...
“Butch Baker
Baker Tire & Alignment
513 w Sam Rayburn
Bonham Texas 75418
65m NE of Dallas
Phone: 903 227 6360”
These guys are not doing that work anymore.
Pete Phillips United Motors in Bonham Texas is who they referred me to. We have used him for several other classic cars. From Alfas to...
I think it is a spun bearing on rod 6. I remember changing the oil from 10-40 to the 20-50, and at the same time used a NAPA Platinum filter. Ever since then, the oil pressure has stayed pegged at 2/3 mark. Downgraded to a NAPA Gold filter, still stayed pegged on the 2/3 mark. Prior to this...
It’s not getting louder with revs, but I can hear it the frequency increase with revs until the transmission and engine get louder than the noise. After removing all the plugs, they need a cleaning or replacement. The noise gets softer when the engine is warmed up. Have not gone as far as...