Search results for query: *

Forum search Google search

  1. Tool Pusher

    When to replace distributor cap and rotor

    My '94 started having a stumble off idle. It idled fine and ran smooth at higher RPMs. But at low RPMs and off idle it stumbled. My first inclination was to check the spark plugs since I had never replaced them after I bought the vehicle over a year ago and did not know the repair history...
  2. Tool Pusher

    Getting the rig put together

    I have posted before, so am not quite a newbie, but I have not posted any pictures of my truck. It is a 1994 FZJ80 with factory lockers, flareless, with an OME heavy lift front and rear, Slee Shortbus front bumper, 4X4 Labs rear bumper, Metaltech sliders, Slee skid plate, CDL switch, 7-pin mod...
  3. Tool Pusher

    Wanted  Viscous Coupler

    Need viscous coupler for 1994-1997 FZJ80. Goes in a HF2AV transfer case. Thanks, David Sword
  4. Tool Pusher

    Oil pressure gauge pegged high

    Today while driving my 1994 80 series I noticed that my oil pressure gauge was pegged high. Pulled over and shut of the engine to make a quick inspection to make sure nothing obvious or drastic was happening. Engine runs normally. When engine is shut off the gauge slowly falls. When engine...
  5. Tool Pusher

    Binding while turning

    Hello, Ever since I bought my 1994 80 series I noticed that when turning sharply, as when in a parking lot, the driveline felt like it was binding. It seems as if this binding is not consistent; sometimes there seems to be little or no binding, and sometimes there is quite a bit. The binding...
  6. Tool Pusher

    New Member/Introduction

    Hello, I am fairly new to the MUD board and have been lurking during that time. I have been a member of the Pirate's board for a while and got a lot of information there concerning my 40, but once I bought my 80 the MUD board has much more information. I would like to thank everyone who's...
Back
Top Bottom