Does anyone have a ballpark estimate on how many turns I need to make on the fuel mixture screw for an FJ60? I tried the lean drop method but screwed it up. Anyone ever write down how many turns????? Thanks!
Went there this weekend and they made up two rattle cans of desert beige. Pretty close to original. Incredibly helpful staff, but unfortunately they were saying they are being taken over by another company starting today. He said it would be a paint store? Hopefully it will be an automotive...
Hi All,
Bought this over the summer and have been throwing money at it since. Recently did the desmog on it (kept the HAC) and some other work including replacing the vinyl on the seats and doing some cleaning. Was going to start working on some body issues but can't find any place that color...
Thanks guys, ran the inner dizzy vacuum to the vacuum advance on the carb. Runs great-ish. Still needs some work but much better. CPT went on manfre and ordered the plate. Thanks much guys!
The small tube is going to the PCV, the big one that went to the valve is hillybilly'ed with a plumbing cap, the threads are a little off so I'm not certain its a perfect seal. It may be leaking a little but not a lot. Thanks!
OK, the last one. I sort of promise. So thanks to the site I got it running and it sounds great. At least in idle. without touching the carb or dizzy it purrs at around 700 rpm on warm idle. However, as soon as you want to move and you rev and let out on the clutch it drops and bogs down...
Capt and OS, thanks. OS you guessed right, I dropped the spaghetti out and didn't put the bolt back in. Get a little coolant leak at the seal of the block and water pump but I think some tightening will work that out.
Thanks very much, I would have been so angry with myself if I dropped out...
So I bought the JimC desmog kit for my 85 FJ60 and spent a few weeks intermittently following the great guide boerick built. However, finished up this morning and started it up and coolant starts flowing out of the front of the engine. When I did the bsv2 plug I lost some coolant because...
So I started removing the smog pump today, thanks JimC for the pulley. All seems good but then I started looking around at other smog equipment and saw the PO had switched lines on the distributor vacuum lines. I went to reverse them and the vacuum line housing disintegrated with rust. I...
I'll try calling Toyota in the am. Thanks. I think I've got a few good leads. I checked the recall and it was done in 1992. The thing is completely rusted and brittle. Thanks again.