thoughts please. This could be mine soon. 60x40 12'wall. (small office, lift, insulate)
Middle Alabama.
Salvageable or start over? 6x6 columns, 12' OC, appear sound. NO verifiable age. Dug down two feet and check one. Looks great. Slight patina on sheet metal roof.
I want to see if you guys...
I'm looking for a cold leak, as in one cup of coolant over three months if and when it sits for 24 hours without starting. Maybe two to three drops on the floor.
Bought all new stuff just in case. I was going to do the top end first and then pressure test with the intake off and then if it sill...
I didn't want to start another AB blinking thread. But I'm at a stopping point.
I reinstalled my engine after a reseal with a new compressor. All was working fine for for the last 5 years with the old compressor.
I changed the evap front and and condenser in late 2019.
After install I...
I replaced it and the front seals a few days ago.
I've always had drips from the window looking at the flexplate. Not bad drips, but drips, and they were getting worse.
Also I had some leak at the front. From either the timing belt tensioner pulley bolt, the front main seal, or low oil pan. (not...
I'm thinking this isn't what was suppose to happen?
it came up with the engine when I lifted it out.
what's my next steps and how bad did I mess up?
I should replace the input shaft seal on the tranny? what else?
it was difficult to get it off before the engine was on the stand, it also...
speculate how this happened.
is it as obvious as it looks? bearing not pressed far enough down the shaft, or bearing not seated on the case side all the way, or not pressing the rotor shaft all the way until the bearing sits on the bore lip?
If that's true, then how did I end up with same...
I made a set up for myself with twin hellas. The difference is night and day. Quicker warm up. Instant ignition, no weirdness.
These will be the best quality you can/could get, or make on your own. They look the same as other maker's HID relays but made with real components.
There are limited...
I'm posting so I don't forget, and because I will lose my notes and this goes hand in hand with an HID relay that isn't garbage.
LC low beam only, LX has different in car connector for low beam.
This info/parts is above and beyond the quality of the 1 or 2 dollar examples available all over...
please don't give me any s***. I'm not saying I'm going to cruise 50k miles with these installed. I do want them to test with, and specifically, I want the flanges welded on already with stock bends and measurements.
trying to decipher part numbers for post 05/2005 production for pipes without...
I found an extra while I was looking for stuff yesterday, and I have lots of free time.
This is the 3rd one I've taken apart in a span of maybe 3 years. All 3 have had different type of wires and differing quality of crimps at the ground and power lines. This one pictured is the highest quality...
Could someone post the headlight diagram hi/lo and Daytime running light relay pages I would be forever grateful. I
trying to make up a LED harness fix for the LX s.
I got a new connector, mine was crumbling. It's been broken and I finally got some new ones. (5 position)
get the white slide thing out with a pick.
then there are two little prongs to lift up and take the outer cover off the connector. Like this
then the front cover comes off and you can...