Worked without leaks when I pulled it out. Swapped it for a delta console. I also have the opposite connections for the a/c lines I can send with it. Helpful if you're trying to put it in another vehicle. Ice trays and tray door are missing.
Here are the lines. One cut had to be made so I...
Looking for a left rear quarter panel fender extension from a 90/91/92 FJ80 or HDJ80/81. This is the rear most left plastic extension piece and is thinner than later models.
I had one fly off in a wind storm. I knew it was loose before I lost it but was a lazy bum. :slap: Any color works.
Hi all, Im in a bind. Ordered the wrong bolt to attach the flywheel for an auto tranny (I think the one I ordered was for a manual transmission). Looks like the bolts are NLA. Amayama has them (if I'm looking at the right part) but it might be fall before I ever saw it given the state of...
Have a rattle that gets worse with RPMs, and it seems to come through the TC shifter knob. I know that really means nothing since the shifter sits on the tranny, but now that I have it all out I can diagnose.
Doesn't matter if its in hi or lo or which direction it turns, its got the rattle. Is...
Im planning on personally rebuilding my 1-HDT next winter. This will be the second engine I have rebuilt, ever. I know this will be a large and costly undertaking, so I want to get a head start on gathering any parts, tools, and collective knowledge that might help me, while starting a thread to...
Just thought Id throw my success up here for guys searching the forum/google.
When letting off the throttle I would get a solid clunk. While diagnosing a loose bearing I saw that the birfield splines had worn and were knife-edged. Same with the drive flange. Needless to say there was a lot of...
This has finally gotten so bad that the vehicle is undriveable. It stutters, has problems idling, and belches white smoke. I think there is an air leak somewhere, and want to get opinions.
I opened up the fuel tank and the strainer looks clear, no black schmoo. Still, it looks like the IP is...
I have quite a rattle coming from my IP. I think the ACSD needs to be addressed soon. Does anyone know where (in 2017) I can source the blanking plate in either the US or CA?
If not, does anyone have dimensions for the blanking plate? Also, if anyone has an extra o-ring sitting around and...
I purchased a kit that included the copper washers but not the o-rings, and I'd rather not pay/wait for shipping from Australia to get them. Does anyone know the dimensions for the 1hdt injector o-rings? I heard Viton rings might be a good upgrade to what Toyota provides. Is there any truth to this?
I'm planning on automating the operation of the cabin blowers. I installed a coolant heater that should trigger the blowers once coolant reaches a certain temperature. The heater is remotely operated, so the fans need to run without keys in the ignition.
My best bet right now is that I can...