Cleaning out the garage and found a couple extras, located in the DFW metro; local pickup available for a little savings.
Brand new Old Man Emu Steering Stabilizer OMESD24 (Should fit 6x/7x/8x series) $80 shipped in the lower 48
Brand new OEM Toyota thermostat for a 1FZ-FE, Toyota...
I have a short side rear axle shaft on my bench right now from an 1988 62, the unworn area between the bearing and seal surface measures 47.51mm (1.871 in.).
x3 on replacing the bearing at the same time; and if you do end up installing a speedi-sleeve, make sure it is narrow and doesn't...
Hello,
Looking for a pair (LH & RH) of good front frame-side shackle hangers from an FJ60/62; I am removing a poorly done shackle reversal and going back to stock. I would take just the brackets if you can get them off clean, or maybe the entire frame end if it is easier. Shipped to 75094...
Hello Tommy,
I am willing to bet Monica's actual suspension lift is a similar height to yours. Obviously the springs/shocks are very different, but the control arm angle/position is likely close. With stock upper/lower control arms we have about 1 degree positive camber; which is slight but...
Looking for a good used set of 4.30:1 gear ratio ring/pinion combo from a 98-01 100 series front differential.
Please PM price shipped to 84405.
Thanks,
I made another batch of these, so I have a whole bunch ready to ship.
$20 for one, $35 for two shipping included.
Paypal is willc60@q.com and put a note that it is for a heater duct
I have an F135 engine that I need to get rid of. It was removed from a 1967 FJ40, internal condition is unknown. I do not believe it was running when removed, I have not taken it apart to inspect anything.
The attached pictures are what is left, it does not have valve cover, oil fill tube...