I still have a few parts from my FJ80 and miscellaneous parts that have been sitting in my shop. I'm not sure what they're worth, but I'd rather not throw them away if someone can use them.
- Pair of FJ80 factory running boards, need painted and have brackets - Pending
- FJ80 Running Board end...
After selling my FJ80, I have a few parts left over. Here is a list of what I have:
- 1 pair of factory running boards with plastic covers. These will need a repaint. : Make an offer!
- 2 full sets of running board brackets. Same as the running boards. : $50 per set
- 1 pair of fender flare...
I noticed that without the running boards on my 80, the rear fender flares look like they're "incomplete". I was wondering if anyone has taken it upon themselves to 3D print a set of caps to make the fender flares extend down to the rockers. The idea I have is similar to what some of my fellow...
After doing a teardown of my LC for some bodywork, I'm short quite a few fasteners and bolts that broke. I'm looking for any body bolts, clips, fasteners, and any other stuff that helps hold on the bumpers and fender flares. I'm still on the fence about putting back on the running boards, but...
I could use the drier lines for the A/C on my 97 FZJ80. The one I need connects from the driver's side A/C crossover /radiator part to the drier (the short one on the silver drier in the picture). Let me know what you have!
Thanks,
Huerta
So, after two months of waiting to get my truck into the paint booth, it'll be going in on Monday! With that said, I had to do a lot of disassembly (front and rear bumpers, fender flares, grille, headlights, valance) to get it ready. In my haste to get it ready, I goofed and forgot to take...
I'm looking to do a little upkeep on the rusty frame of my LC, and I'm looking for something that will help with preventing further rust. I'm not looking to grease up the undercarriage just yet, as I want to take care of the rust issues beforehand with prep and paint. I'm looking at a product...
I'm trying to finish up restoring my 40th Anniversary Land Cruiser, but I'm still a little short on some parts, namely the Driver's Side interior door handle, the front passenger side overhead grab handle, and a load of miscellaneous bolts that hold on the fenders and trim pieces. Please let me...
I know this is a bit of a stretch on a FJ website, but I figured I'd give it a shot! Looking for a 99-02 4Runner front bumper. Let me know what you have.
Thank you,
Huerta
I know this seems like some ticky-tack stuff, but I'm trying to piece together a rusty 97 FJ80 and would like to find some parts for it so I can restore it.
- Front wiper arm bolt cover - little plastic piece that covers the bolt.
- Fender flare bolts, nuts, and fasteners
- Any bolts and...
So I purchased a rear bumper cover for an LX450 to cover the center of the bumper (where the aluminum plate sits) and I was wondering if anyone had attempted to install this on an FJ80 or if it's simply not possible. I've looked on the site here and haven't found any information on this, but if...
I'm looking for a set of AC lines that run in front of the radiator to the collector that sits in front of the radiator. Mine were damaged by the PO in an accident. Much appreciated!
-Huerta
I know this is a bit of a stretch, but I'm looking to buy a FZJ80 front bumper corner for either side. They do not need to be new or perfect in condition. I could use one that can be repaired. Shipping is to 68926. Thank you!
I'm looking to buy a set of fender flares for my 97 FZJ80. Does anyone have a pair of front flares or full set of flares that they'd be willing to part with?